Bosch Dishwasher Cable Or Retainer

Hinge cable connects the dishwasher door to the tension spring. Replace if broken, frayed, disconnected, or causing door to drop when opened.

Replaces broken or worn dishwasher door cables and springs. Controls door opening and closing. Includes cables, springs, and mounting hardware.

Connects dishwasher door to spring mechanism for smooth opening and closing. Replace if cable is frayed, broken, or snapped causing door to drop freely.

The Roller and Cable Assembly is an OEM part for Bosch dishwashers. This assembly includes the roller and cable, which work together to facilitate the smooth operation of the dishwasher door, allowing it to open and close effortlessly.

Over time, the roller and cable can wear out or become damaged due to regular use, friction, or accidental mishandling. If either component fails, it can affect the balance and movement of the dishwasher door, making it difficult to operate.

Symptoms of a bad roller and cable assembly include:

• Difficulty in opening or closing the dishwasher door
• A sagging or misaligned door
• Unusual noises when operating the door
• The door not staying securely in place

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

Door pulley rope for dishwasher door latch mechanism. Replace if frayed, broken, or snapped from repeated use. Includes rope and plastic retainer.

Support strap that cushions and secures the dishwasher circulation motor, stabilizing the motor assembly to reduce vibration and help maintain alignment for steadier, quieter operation. Designed for circulation motors with softer bearings. What it does:

• Cushions and supports the circulation motor to limit movement and vibration and reduce motor noise.
• Secures the motor assembly to the tub/chassis to maintain proper clearance and fit.
• Helps prevent undue stress on motor bearings and mounting points that can cause premature wear.
• Commonly replaced when the strap is cracked, stretched, or no longer holds the motor firmly in place.

• Disconnect power and water supply before servicing; follow all safety and OEM service instructions.
• Remove access panels and any obstructing components to reach the circulation motor as required.
• Replace using the original mounting hardware; inspect motor mounts and bearings while accessible.
• Reassemble and run a short test cycle to confirm reduced vibration/noise and proper motor operation.

Cable retainer link kit for dishwashers. Secures and connects cables inside the dishwasher door assembly. Replace if cracked, broken, or missing.

Replacement electrical cable harness for dishwashers. Installs inside unit to restore power connections. Replace if original is damaged, frayed, or worn.