Ge WB32X10013 Range 8 Inch Drip Pan OEM Part

With the help of Wendee and Karen, we finally figured out my model numbers and which parts where correct. I ordered the parts and all arrived the next day except for the Broiler element which arrived in 2 days. I installed the new Baking Element myself. Took longer to figure out which curcuit braker to turn off. In about 30 minutes I had a brand new Baking Element in my oven working perfectly. On the following day, I installed the Broiler Element. That took a bit longer as it sits in a metal sleeve and then needs to slide into place with the end pieces lining up with two holes so the ends enter there. First I installed it by itself and turned the curcuit brakers back on to make sure it would work. Once I confirmed it worked I had to install it with the metal sleeve and that took a little bit of time, but with a little patience it finally lined up. Then on Saturday, my husband and I installed all four burners on the stove-top. Two six inchers and two eight inchers. It was a two man job as we used the new ceramic blocks which my husband held in place after securing each wire to the new burners and clips needed to be slid on it as my husband was holding it. I now have a brand new oven and stove-top. My house was built in 1958 so most likely my model is a 1957 GE J502P1 for the oven and the stove top is a J5521N1 which has push buttons on the wall to operate it. The customer service I received was amazing. Top Notch. I might actually continue to fix up my kitchen keeping all the original appliances as they have so much charm and work beautifully now. My kitchen is avocado green but the appliances themselves are a beautiful stainless steel. I cannot say enough about the Customer Service at appliancepartspros.com. They were so helpful and always available by phone or email. I did watch the videos posted about installing the baking element. Unfortunately there is no video on how to install the burners or the broiler element, but if you systematically take the old ones apart, you can retrace your steps and reattach the new burners. The broiler was not hard, but lining it up was a little tricky. Take your time and you should have no problems. There were some videos on youtube for the burners but none were as old as mine which has four ends sticking out of it instead of two. The two armed burners just pull out and slide in. The four armed ones need to have the ceramic block in place. Good luck with your appliances!! Happy Cooking/Baking!

I searched on line to find the replacement parts on Wednesday and received my complete order on Thursday. After receiving my order, I easily replaced the old drip pans and rings. It was a snap! Thanks for your rapid response to my order.

Searched high and low for these parts for my older GE stove/range/oven. I found them on your website more reasonable than most with quick service. I've very happy with the quality and fit perfectly! Should have ordered a couple more as spare.

Ordered new parts and replaced all. Had to slightly modify the wire terminals all four surface elements so that they would fit the ceramic insulators that were shipped with each one.

Got replacement part for my very old GE oven. Hardest part was reaching inside the oven to get new screws threaded into the new element.