General Electric Dryer Cable Or Retainer

Secures the drive motor to its mounting bracket. Replace if cracked, broken, or missing to keep the motor and blower aligned and stable during operation.

This molded wire tie standoff provides a secure anchor point for a cable tie to hold wiring and harnesses away from moving parts and hot or sharp surfaces, helping reduce wear and electrical risk. Fits common HVAC and appliance wiring panels. What it does:

• Anchors wire ties to the appliance cabinet or chassis so harnesses stay routed and secured
• Prevents wires from rubbing on sharp edges, hot components or moving parts
• Helps stop intermittent electrical issues from loose or vibrating connections
• Reduces noise from loose wiring that can vibrate during operation

• One wire tie standoff

• Disconnect power before servicing the appliance to avoid shock or damage
• Mount in the original standoff hole or approved panel location; secure a cable tie through the top loop to hold the harness
• Use the correct fastener or snap method for your model—do not force or overtighten
• If routing or attaching multiple wires, verify clearance from heating elements and moving parts

Plastic flat drive belt for dryers. Transmits motion between components. Replace if worn, cracked, broken, or slipping to restore smooth operation.

This inner door sub-assembly is the factory replacement inner panel for the appliance door. It restores the door's inner structure and supports the inner glass and trim for safe, stable operation. What it does

• Replaces a damaged or warped inner door panel that can allow heat/steam to collect between door layers
• Secures and supports inner glass and related trim for proper door alignment
• Reduces rattling or vibration caused by a loose or broken inner door component
• Helps restore a proper seal and consistent cooking/heating performance when the inner panel is compromised

• One inner door sub-assembly

• Disconnect power (and gas, if applicable) before beginning any repair; ensure appliance is cool
• Handle glass and sharp edges carefully; wear gloves and eye protection
• Follow the OEM service manual for disassembly/reassembly steps and recommended fasteners

Secures the dryer motor in place within the cabinet. Replace if strap is cracked, broken, or missing to properly mount and stabilize the motor assembly.