Jeffrey M Pensacola , FL February 06, 2015 Broken end caps broken handle I removed end caps installed one end cap fitted handle to this end cap then fitted 2nd end cap to handle then attached this end cap to stove door. Read More... 31 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Joy T Tampa , FL September 26, 2016 Broken oven door handle and ends Took off old parts and fastened new ones on. Not as difficult as I thought it would be. Read More... 19 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers, Socket Set
Anthony W Garden Grove , CA February 28, 2015 Appliance: Model AP2019449 AND AP2020944 Oven door handle replacement for ge oven Had a little trouble getting the correct part number, but with the help of Appliance Parts Pros very knowledgeable customer service. The correct part was ordered. Removed two screws to access inside panel of door. These screws also secure the door handle. Removed an additional 4 screws to completely remove the old handle. Assembled the new door handle consisting of three pieces. Attached the door handle to the outside of the door with the four screws. My oven door had alignment holes for the alignment pegs that are located on the door handle assembly. Then close the inner panel and fasten with the two remaining screws. The handle has locating pegs on it, so when the panel is closed the two remaining screw holes on the panel should align with the additional holes on the handle that accept the two remaining screws. Read More... 13 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers, Socket Set
Robert B Louisville , KY November 26, 2018 Appliance: General Electric Electric Range JBP75AV1 Range door handle end cap broken jbp75 Remove 2 screws from liner to handle, remove 4 screws from bottom of door attaching panel to liner. Lift panel from liner and lay out with inside facing up. Remove one screw from each side of panel attaching handle end cap. Remove handle assembly, replace cap, and reassemble in reverse order. Almond color handle and end caps are no longer available, had to replace entire handle assembly with black, but it looks pretty good. . Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Dorothy H Moscow Mills , MO June 21, 2019 Appliance: Model XL 44 RANGE Oven handles broken Replaced parts and installed Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers