Kitchenaid Blender Cap Or Cover

Replacement pusher for food processor feed tube. Safely guides ingredients through the chute during operation. Replace if cracked, broken, or missing.

This washer lid assembly replaces a cracked, broken, or misaligned lid so the washer can close and lock correctly, restoring safe operation and reducing cycle interruptions caused by a lid that won't align or latch.

• Covers the tub opening and aligns with the lid lock/strike for proper engagement
• Restores the safety interlock so wash cycles can start and run without interruption
• Helps contain splashing and keeps debris out of the washer when not in use
• Typical symptoms include visible cracks or shattering, warped or loose lid, broken hinge area, or intermittent lid-lock errors

• Disconnect power before servicing
• Protect the cabinet surface and support the lid during removal/installation to prevent damage
• If required by your model, transfer existing hinge hardware and fasteners to the new lid
• After installation, check alignment and ensure the lid lock engages smoothly before running a cycle

This replacement pusher fits the refrigerator's ice dispenser/ice-bucket assembly and helps drive the mechanism that moves ice through the chute. Replacing a worn or broken pusher restores smooth, reliable ice dispensing.

• Engages the dispenser/crusher linkage to advance ice from the bucket toward the auger and chute
• Supports crushed/cubed selection on models equipped with that feature
• Wear or breakage can cause weak or no dispensing, jamming, or being stuck in one mode
• Visible cracks, deformation, or missing plastic are common failure signs

• Disconnect power to the refrigerator; remove the ice bin
• Access the ice bucket/dispenser mechanism and note the original pusher's orientation before removal
• Reuse existing screws/clips as needed and confirm the mechanism moves freely after installation
• Reinstall the bin, restore power, and test both cube and crush dispense modes

Replacement pusher for food processor feed tube. Guides ingredients safely into the blade assembly. Replace if cracked, broken, or missing for safe operation.

Replacement bowl cover for food processor work bowl opening. Restores protective surface if original cover is cracked, broken, or missing. Direct fit.

Protective cap for blenders that covers exposed shafts and openings. Replace if cracked, broken, or missing to prevent dirt and debris buildup.

Complete blender lid assembly that securely covers the pitcher during blending. Replace your cracked, broken, or missing lid to prevent spills and splatter.