Maytag Washer Dispenser Parts

Found the parts on appliance parts pros and ordered them. It was amazing one arrived the next day and the other just the day after that it was so quick! There wasn't any real assembly just pulled the old drawer out and put in the new one! Read more

• Will not fill with water

After watching the YouTube video provided by Appliancepartspros and checking various forums I determined the dispenser motor had gone out. Turns out, it was a two part problem. The connectors to the motor, and the motor had corroded. Cleaned them both with vinegar. The old motor did a load before I started having problems with the CCU. I didn't learn about the CCU needing a reset under the quick diagnostics until after replacing the motor and the new part doing the same thing. Both the new... Read more

Bought a new one one and slid it in myself. Read more

The soap dispenser had a broken water valve, and I had to replace it with the new one you sent me, and it works perfectly. Read more

Purchased a fabric softener dispenser from appliance parts pros removed cap from agitator and replace with the new fabric softener dispenser and problem solved. Read more

I purchased part #85753076A, Whirlpool Fabric Softener Dispenser. Popped off the top from the agitator and popped on the fabric softener dispenser. It took me less than a minute and it works perfectly! No more missing the rinse cycle!!! Read more

• Will not drain

Checked the circuit board to see if R11 was burnt and it was. They told me if the wax motor had a brown tip that I would have to replace the Machine control circuit board as well as the Wax motor. I ordered the new parts put them in and it worked. Read more

The washer would work fine except it wouldn't spin unless you opened the lid and waited a split second for it to stop. You would hear a bang, then when you closed the lid, it would spin. Since it made that bang noise, I thought the transmission was going bad, so I replaced that. Nope, still the same. So, after a little more research, I found out that the motor has to come to a complete stop for the transmission to go into spin mode. After pulling out the timer and inspecting it, I noticed... Read more

Appeared to be two problems: the latch was worn and one of the pins that slid in a guide on the actuator located in the inner panel had broke off. Detergent lid spring and pin appeared to be OK but decided to replace since I was aready working on it. I ordered all the inner panel mechanism from the control arm to the latch actuator on the inner panel. The repair was successful as the detergent dispenser now opens during its cycle. Read more

I removed the old one, broken bits and all. I replaced it with the new one. Read more

My appliance is a Kenmore, and even though the video mentioned lots of other brands, it showed the exact same problem I was having. My dispenser motor just spun and spun, never stopping at the various positions it was apparently supposed to. Then it would trip the F30 code. The part description again mentioned these other brands but did say in fine print it fits some Kenmore products. I could tell visually from the video the part was the same as on my washer so I felt confident the part... Read more

Replaced tray, The only difficulty was connecting the drain hose to the bottom of the tray. Difficult to get hand on the hose. Read more

Had to buy a new draw handle and detergent draw..they attach together by two plastic tabs that take a lot of stress each time you open it..unfortunately had to buy both to fix the problem.. Read more

This company is great & I highly recommend it to anyone. I was beyond pleased with the customer service when I called to order my part. The price was unbelievably cheap. I ordered it on Friday at 5:00 pm & it was delivered less than 24 hours later! I will definitely use A.P.P. again. Read more

Ordered a new one and put it in. Read more

Found and ordered another one, worked out great. Good seller, quick shipper. Read more