D.D.S. October 02, 2012 for Model Number SDG2606AWW If the gas valve won't shut off can the valve be repaired? I just got the dryer and I don't know if it was switched over to propane. Would that cause the valve not to shut off?
1 Answer Hello, The gas valve WP37001127 cannot be serviced, only replaced. You don't want to service a valve that could be an explosion hazard. Also, the gas supplied to the valve will not cause a valve failure unless the gas is contaminated. Your best choice is to replace the valve. Read More...
Dds October 02, 2012 for Model Number SDG2606AWW When my dryer shuts off i smell strong gas , no leaks in gas pipe conections.
1 Answer Hello DDS. If nothing is leaking in the gas supply, then the valve WP37001002 is not shutting off and will need to be replaced on the unit. Read More...
Matthew W. June 11, 2012 for Model Number SDG4606AWW Gas dryer flame comes on when first starts, but flame goes out during the cycle. Ignitor comes back on but flame does not. Ignitor comes on a couple more times but flame does not. If I wait awhile before I restart, the flame will come on again. Dryer is serial # 10039168CN Thanks, Matt
1 Answer Hello Matthew, You have a bad coil on the safety valve. The two coils come in a kit 279834. Read More...
Lyle September 30, 2011 for Model Number sdg3606aww The burner comes on at first for a few seconds. then have to wait 2 or 3 hours for it to do it again. The piolet light does come even though the burner does not. thanks LYLE
1 Answer Lyle, Based on your post description, you have a weak set of gas valve coils 279834, its not likely you need a gas valve assembly, Thanks and good Luck Read More...
Jim August 03, 2011 for Model Number Maytag SDG305DAWW My dryer does not heat, the igniter comes on but no gas. I checked the continuity on all the parts including the coils. All seem to be functioning properly. can you help?
1 Answer Jim, You still have a problem with the gas valve coils, most likely 279834, you may want to check the coil resistance again, but wait until you've run the dryer for 15 minutes first. Good Luck and Thanks. Read More...
John H. May 02, 2011 for Model Number sdg3606aww Gas dryer flame comes on when first starts. Flame goes out after cycle then glow plug comes back on but flame does not. Dryer glow plug comes on couple more times but flame does not. I have to wait awhile before I restart and flame comes on once again. Sensors test good and I have new solenoids.
1 Answer Hello John! To help verify which part numbers you will need to order we will need your serial number. Thanks. Read More...