Customer Questions and Answers for Electronic Control Board by Whirlpool

Nicki, No, your range doesn't have a thermal fuse. The most likely issue is a spark module issue WPW10331686 located in the control panel. Here's some testing information " First thing, check and make sure the power cord is attached to a properly polarized and grounded 120 VAC outlet. A proper ground is very important for the range to operate properly. Then you'll need to make several tests at the gas distribution valve.You'll need a multi meter to test voltage and resistances. At the valve body terminals, with the wires labeled and remove from the middle terminal to each of the outer terminals, you should read 215 ohms resistance.With the wires reconnected, when you select the bake cycle, you should have a reading of 8 to 18 VDC across the red and orange wires. When you make a broil selection you should have the same 8 to 18 VDC,across the orange and blue wires. If all checks are proper replace the gas valve assembly WPW10293048 . Thanks and Good Luck

Hello Mario. According to your model number, the igniters inside the oven are spark igniters. In that case it could be the spark module. Hope this helps.

Hello Mario. If there is no spark at either oven igniter, then the spark module WPW10331686 may be bad. Hope this helps.