Lou August 12, 2014 for Model Number MAV7700AWW I removed the hose to the pressure switch and blew through it and there was no restriction at all...is this normal?
Lou August 11, 2014 for Model Number MAV7700AWW Why does my washing machine drum keep filling up with water and in order to stop it I must push the dial in and set it to the spin cycle to drain the water?
1 Answer Hello Lou. If you can stop the water from entering the machine by turning off the timer or unplugging the unit, you will need to look for a bad pressure hose or replace the pressure switch. If the only way to shut off the water is at the shut off for the water hoses, you will need to replace the water valve in the unit. Read More...
Shane July 01, 2014 for Model Number mav7600aww My washer will not let cold water into the tub even on cold/cold cycle.
1 Answer Hello Shane. Test for power to the water valve. If there is power there, you will need to replace the water valve WP22002708 on the unit. Read More...
Mark February 27, 2014 for Model Number MAV7600AWW, sn#21268309A Stumped,..washer does not drain completely, requires resetting timer to spin second time to drain completely. Have replaced drive belt, pump and motor tension spring, all lines clear, no leaks,...same issue. Have read your repair help, assume next step is timer? Water level switch? Any advice/tips appreciated before I go broke buying parts. Thanks
1 Answer Hello Mark, Make sure the unit is leveled and cannot rock. Insure the center pulley is not contacting the floor. Replace the thrust bearing kit if there is no rough feel or sound when turning the drum manually. If there is a roar during spin, the issue can be the tub bearing and seal kit. Be sure to check the lower spin bearing for noise also. The thrust bearing kit 12002213 is the part of the machine that releases the brake for the spin cycle so it is a common part to fail. Read More...
Ccp June 11, 2012 for Model Number W10133484A or 4619 702 39101 F35 Suds error possibly need pressure switch for Whirlpool Duet Steam washer.
1 Answer Hello CCP. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Jeff April 09, 2012 for Model Number MAV7757AWW On the cold water cycle (haven't tried any other cycle), my machine runs cold water continuously, but the tub never fills. The water just drains right back out. Might the problem be the pressure switch?
1 Answer Hello Jeff, This sounds like a siphon situation. You need to insure that the drain line is at least as high as the main top of the unit. If it is, you need to make sure the drain line is not taped or sealed to the standpipe. To answer your question, the pressure switch can in no way cause this problem. Read More...
Shane February 22, 2012 for Model Number mav7600aww Water keeps running does start washing after I mess with the size switch would this be the pressure switch?
1 Answer Hello Shane. Yes, based on the information you provided, it sounds like the pressure switch 22002705 is bad and will need to be replaced. Hope this helps. Read More...