Roper Washer Wire, Harness, Power Cord

Replacement power cord that connects your washer to the wall outlet. Includes strain relief for cable protection. Needed when original cord is damaged, pinched, shorted, or worn. Direct plug-in installation.

This ground wire provides a safe chassis connection to restore proper grounding and reduce shock and electrical-fault risk. It replaces a frayed, corroded or missing ground lead to help keep the appliance electrically safe. What it does

• Connects the appliance chassis to the grounding system to prevent stray voltage on metal surfaces
• Restores a secure ground path if the original wire is broken, loose, or corroded
• Helps stop intermittent power faults or nuisance tripping caused by a compromised ground
• Addresses symptoms like visible wire damage, loose ground connection points, or grounding-related electrical issues

• One ground wire

• Always disconnect power (unplug or shut off the circuit breaker) before starting work
• Attach the ring/terminal ends to the designated chassis ground screw and the equipment ground point
• Route the wire away from moving parts, heating elements, and sharp edges; secure with existing clips or fasteners
• If terminal hardware is missing or damaged, replace with equivalent OEM-style fasteners and torque to specification

Replacement power cord for washers. Connects your washer to the wall outlet. Replace if your cord is damaged, frayed, cracked, or missing.

This wire harness assembly routes power and signals between appliance components to restore proper electrical connections and reliable operation. It replaces a damaged or worn harness to help eliminate wiring-related failures. What it does:

• Provides the main electrical connections between controls, motors, switches, and sensors
• Transmits power and control signals so components respond correctly
• Replaces frayed, burned, or broken wiring that can cause intermittent function
• Helps address symptoms such as components not powering on, intermittent operation, or loss of specific functions

• Disconnect power (unplug or switch off breaker) before starting any work
• Note connector locations and routing before removing the old harness; reinstall in the original routing
• Inspect connectors and terminals for damage; replace harness if insulation or wires are compromised

Wire harness assembly for washers. Connects electrical components and control systems. Replace if wiring is damaged, frayed, or connectors are broken.

This wiring harness assembly routes power and signals between components to restore reliable electrical connections and normal appliance operation. Use it when original wiring is damaged, corroded, or causing intermittent power or control issues. What it does:

• Transfers power and control signals between the appliance control, motors, and sensors
• Replaces frayed, broken, or melted wires that cause intermittent operation or component failures
• Restores reliable connector-to-connector continuity for proper appliance function
• Helps eliminate error codes or non-start conditions caused by open or shorted wiring

• Disconnect power (unplug or shut off breaker) before starting any repair
• Compare the new harness to the old one to ensure connector types and routing before installation
• Route and secure the harness using existing clips/holders; avoid pinching or routing near heat sources
• Test the appliance after installation and restore power only when all panels are properly reinstalled