Whirlpool WP9708175 Planetary OEM Part

The vertical shaft showed a slight bend so I replaced the bent shaft with a new shaft. I should have done that when I was replacing the gears. Although we have not mixed any more bread, I ran the mixer at a both low and high speeds for several minutes without any more gear clashing noises. It now purrs ! The top bearing on the original vertical shaft had slipped down the shaft when I first examined it. This may have been the source of all of my problems with this mixer. It may have been manufactured or assembled incorrectly. But we got about 18 months of success before needing the gear and shaft repairs.

Tore down transmission gear case of my Kitchenaid Professional 600 stand mixer and replaced worn components to include front and rear sleeve bearing, worm gear thrust bearing, worm follower gear, drive shaft retaining clip, center shaft o-ring, and dowl pin. Additionally, replaced black plastic transmission housing with metal one and new gasket, replaced entire planetary assembly, and repacked transmission with OEM food grade grease. After tear down, but before rebuild, l cleaned all components completely of all old gear grease including leakage in stand mixer itself. Note: Kitchenaid has not made an engineering change to the driveshaft/planetary assembly. The drive shaft is tension fit to the planetary. Over time and use, this tension is lost and the planetary plate slips down and eventually off the drive shaft. So, this repair will need to be completed again sometime in the future. I would have rated this experience 5 stars had this been corrected.

By replacing the planetary, the problem was resolved with no further damage to the unit. The job was easily completed, though it would have helped A LOT if I had a set of snap ring pliers. Otherwise the job was easy.

My husband took it apart and we ordered a new planetary, he just put it back together and it works like new. I just want to say that we were unsure of the part to order so we called in to appliance Parts Pro and talked to a man who was the absolute most help we could ever ask for! He did the order and everything was perfect and I am delighted to have my mixer again.

Replaced all the gears due to stripped worm gear and metal contamination in the grease, repair was easy, mixer works just like new again, it lasted 12 years