Stephanie B Wetumpka , AL March 15, 2014 Drier would not turn on. You could hear it hum, but display wouldn't light up. Purchased a new control board Read More... 42 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Ralph F Sanger , CA July 13, 2016 Display was flicking display went out and a humming coming from inside of dryer Replaced power board. Read More... 11 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Leslie S Oxford , MI January 22, 2017 Appliance: Maytag Gas Dryer MDG9700AWW Dryer would not run Installed igniter but turned out not to be the problem. Control board hummed, replaced it and now it works. It did turn on, I have to run some clothes in it to make sure that the control board works under load. Read More... 10 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Dikran S Valley Glen , CA February 07, 2020 Appliance: Maytag Gas Dryer MDG9700AWW Drier would not turn on you could hear it hum but display wouldn't light up I replaced the Control board as mentioned at Appliance Parts Pros.com repair section problem and answer. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Jaime H Pearsall , TX October 04, 2015 Beeping noise on dryer no lights on panel Replace with new control board . And now working like new. Easy and simple to remove and install new part. Very happy that I found appliancepartspros.com thanks Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers