Darren A Claremont , NH November 29, 2014 Appliance: Maytag Washer- Horizontal Axis MAH3000AWW Door wouldn't lock so therefore no spin cycle Verified that wax motor had power and ground, witch it did. Checked resistance value of wax motor, was about 1200 ohms. Seems to be correct value. Ordered new wax motor and asked tech line about it. They pretty much insisted it was The $214 Control Board. I questioned there judgement, they asked me to inspect the control board for burnt components. It did in fact have a few burnt resistors. I replaced Control Board and wax motor, It corrected the Problem. Read More... 19 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers
Bryce B Riverton , WY May 13, 2018 Appliance: Model MAYTAG NEPTUNE Door would not lock on the washer Watched video that diagnosed the problem and then videos on how to repair the washer. Ordered parts from AppliancePartsPro. It all went very well. I'm only so so with tools but with the clear and easy to follow videos I managed just fine. Probably saved a couple of hundred dollars and didn't have to wait for the repair guy to show up, Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Dave P Greenville , WI October 03, 2017 My problem was my Maytag Neptune wasn't doing the spin cycle. I am getting three new switches. Joe M is very helpful, he knows his stuff. I should get my machine up and of running by the end of the week. Let you know then. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers, Socket Set