Charles H Avon Park , FL May 08, 2017 There was a hole rusted in the box burner I first DISCONNECTED POWER FROM THE RANGE using the breaker. I then pulled the range out from the wall to give myself plenty of working room. I lifted the range top up as when you clean under the burners. I then moved the ends of the bottom of the slide rods that lock the range top open back where they came loose from the top of the range. This allows you to fold it higher and have complete access to the top of the range. I then took out all the Phillips head screws that hold down the sheet metal pan called the Box-Burner. There are 2 in the back that are a bit of a challenge and I found I needed to pull the pan forward a little bit and use a stubby screwdriver to remove the back screws. Took the old pan off and laid the new one on. I replaced all the screws starting with the 2 in the back again a little bit of a challenge and needing a stubby screw driver to get at them. Lower the range top while engaging the slide rod catches. Unlatch the slide stops and lower the slide stops the rest of the way. Pushed the range back, restored power, and tested. I would say it is a very easy job for anyone that is handy. Well worth your time and you will be saving money. Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Fearon W Sunrise , FL June 17, 2016 Box burner burned out Replace it Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Roxanne S Miami , FL December 29, 2014 The box burner had rusted and had holes in it Unscrewed the old box burner and replaced it with a new one. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers