Kim K Murrieta , CA November 01, 2020 Dryer just needed some new parts The front panel clips needed to be replaced as they were bent and the some of the tabs for the bearing ring had broken off. Very pleased with the price, the parts and the quick delivery. Thank you. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Ed S Rehoboth , MA April 13, 2018 Drum would not turn. Video was helpful for removing front panel. The drum belt had slipped off the driveshaft. Easily repositioned..The dryer is about 30 years old. The bearing front support had become brittle and cracked. Replacing it was straightforward. I found that tilting the dryer back to position the drum on the rear support made replacing the front panel much easier. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers
Tony L Kendallville , IN October 09, 2015 Belt broke Well when I got my parts on Tuesday 10-6-15 I replaced the belt and idler pulley and two new door clips and put all back together works great but I still mite need to replace element anyways on going to use it and if need a element I know where to get it and fast you guys are the best and thank you for help tony Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
John S Mandeville , LA June 05, 2016 Idler pulley roller bearing freezing up Replaced idler pulley as per your instruction video. Only semi difficult part of procedure was reattaching spring, spring tension made it a little trying. Total replacement took only 30 minutes start to finish. Your instruction video was a GREAT help, Thanks Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers, Socket Set
Richard M Pocomoke City , MD January 09, 2016 Appliance: Model KENMORE 110.86573120 Dryer rear drum support rollers were bad and drive belt layers were separated Replaced the rollers and the belt. To help thread the belt under the tension roller and onto the motor pulley, I supported the drum in place.. I used a string passed under the front of the drum and tied to the top of the side panels. Your video of roller replacement was pretty good: But perhaps you might want to add this trick to it. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers