Whirlpool WP22004469 Leveling Leg (Rear, Self-Leveling) OEM Part

I followed the Appliance Parts Pro's advice videos for the Maytag MAV6451AWW Atlantis washer on replacing the snubber ring and the suspension springs. Everything went just fine except replacing the two rear most suspension springs. None of the videos illustrated REINSTALLING the REAR springs which is extremely difficult because you can't get enough leverage with your arm extended. Observing my frustration, my wife recommended taking off the back side. You can't simply take off the back, because the right and left sides and the back are one piece. LESSON LEARNED: Follow the video to remove the front, then use duct tape to secure the lid to the left and right sides, and then remove ALL the screws around the base after removing the pump, motor and all hoses including the small water level sensing hose attached to the left rear of the tub. Make sure the motor wiring harness is unhitched from the base clip. Put on gloves because the edges are sharp, and then get your wife to help lift the remainder of the frame up and off the base. This makes removing the suspension springs and replacing them a piece of cake. Doing this originally would have saved hours of frustration.

After looking on your site for the symptons, I decided to change the snubber ring (the original ring did not look all that worn but changed it anyhow), all 6 suspension springs and the 4 front/rear legs. The rubber pads were worn out almost completely on all 4 legs. The repair went smoothly except when trying to set the pin in one of the rear leveling legs. I didn't look at the installation video which I should have, but I was able to get the pin in securely. I made a slight adjustment to the left front foot pad to make sure the machine was completely level before operating it. Now when the machine is in spin mode it is as smooth and noise free as brand new. My wife did about 6 loads of laundry over the weekend and was quite happy. In conclusion, I'm not sure which part or all the parts changed that made the difference, it still beats spending $800+ for a new washer.

*GREAT! *Parts arrived quickly and the job was fairly simple to complete. Thank you!

I previously replaced the 6 springs on the tub. I replaced the 'snubber' ring. I replace the drive belt. But the problem was the same. So this time, I replaced the auto adjusting rear feet. I replaced the stationary front feet. Yet, the problem remained. My neighbor repairs manufactured homes. He said the floor where the washer sits, needs to be structurally strengthened. He said the washer is not the problem, it is fine. He told me to move the washer outside, to my concrete patio, and wash a load of clothes. I did. And the washer ran like it was brand new. Not even the slightest bit of shaking. My neighbor is going to help me structurally reinforce the floor in my manufactured home, where the washer sits. The washer is 20 years old. I do believe it was correct of me to replace the parts that I did. I think the 'climate change, energy efficient' washers of 2022 are awful. I hear their expensive 'computer circuit boards' die after a year. Happy washing.

My 25 year old Maytag PAV2200AWW washing machine struggled to stand still! I went to find a blow-up parts list to see if it was something I could repair. AppliancePartsPro.com had the information and repair video as well. The "Snubber ring" seemed like the obvious culprit. When I pulled the washer out to examine, I found the feet needed replacement as three of the four were bare metal on the floor. I thought I should order a new belt and suspension springs while I had it apart. The front legs were discontinued so I had to order something similar from somewhere else. The rear legs were the hardest part of the repair because they were a "self-leveling" contraption. Each leg had a roll pin that had to be knocked out to remove the old legs. This took the longest for me. I also had to grind/file the pin to get it into the new legs. Put it all back together and it works like a charm!