Robert H Alpine , TX February 14, 2015 Washer would fail to complete spin cycles I started by replacing the lid switch without the desired result. So I decided to replace the timer unit. It works like a new machine at the moment. At least on the first trial load. More loads will convince me that it is fixed for sure. I cannot be more complimentary about Appliance Parts Pros as I live very remotely in West Texas. The part arrived quickly and it was the exact right part required as ordered. This is my second order and I will return for more parts if I need them. Read More... 12 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers, Socket Set
Dennis J San Ramon , CA December 15, 2014 Appliance: Model KENMORE 11023822100 Kenmore 11023822100 does not drain/ spin after wash/rinse agitation Replaced timer Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Neil J Gastonia , NC February 07, 2015 Washer would not spin Replaced the timer. Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Norman W Bismarck , ND May 18, 2020 Appliance: Kenmore Washer 11023832100 Worn out contact in the timer not allowing it to spin/ The washer would work fine except it wouldn't spin unless you opened the lid and waited a split second for it to stop. You would hear a bang, then when you closed the lid, it would spin. Since it made that bang noise, I thought the transmission was going bad, so I replaced that. Nope, still the same. So, after a little more research, I found out that the motor has to come to a complete stop for the transmission to go into spin mode. After pulling out the timer and inspecting it, I noticed that one of the contacts wasn't opening hardly at all and it was burnt looking. It wasn't allowing the motor enough time to stop, so it wouldn't shift into spin mode. Replaced the timer and it works like new again. Plus, since I put in a new transmission, it's quieter too! Replacing the timer is about as simple as it gets. Watch the video and you will see what I mean. All you need is a 1/4" nut driver and a Phillips screwdriver. Took less than 5 minutes. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
John M O'fallon , MO August 19, 2015 Washer timer had several bad contacts in it Replaced the timer. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers