Orion for Model Number SHE55R55UC/64 Initially while running DW my ten year old Bosch DW in Auto mode, it would progress thru the cycle until cycle countdown read 1 and essentially hold at 1. When I opened the door there was water remaining in the bottom. I pressed the cancel/reset and the drain pump kicked on and removed all remaining water. At that point I investigated the drain pump impeller and check valve and all was well. I did a “re-boot” of the system by powering down for about 15 minutes and then powered the DW back on. After that I did several test runs in both the Auto and Normal modes and all was working. Fast forward to today, about five days since the re-boot and again while running in the Auto mode, the DW failed to properly rinse and drain. I did the cancel/reset and once again drain pumped kicked on and removed the water. I have no visible error codes or anything more to go on. Might it be the turbidity sensor, or control board, or something else. Looking for ideas on what direction to point.
Answer Orion, With this being an intermittent issue, the control board will be the most likely cause for this to occur. Read More... Answered by AppliancePartsPros.com | Wednesday, March 23, 2022