Parts for Frigidaire MGF303PGDC: 03 - Burner Parts

If your range burner won't ignite, stay lit, or adjust flame properly, the top burner valve may need replacement. Restores precise heat control.

By Frigidaire. 2+0 module type. Employs two spark electrodes for manual surface ignition of a four burner range top with flash tubes to front and rear burners. Very popular module used on many different brands and models. Check by appliance model number, if not sure.

Replace your cracked, rusted, or clogged gas range surface burner. Mounts on the cooktop to direct gas flow for a steady flame. Easy one-screw install.

Replacement top burner for gas ranges. Installs on the cooktop surface to provide flame for cooking. Order if your burner is rusted, eroded, or broken.

Cable retainer for cooktop installation. Secures wiring harnesses in place. Replace if broken, cracked, or missing to properly organize internal cables.

This pressure regulator controls the gas flow to a range or cooktop, restoring proper burner performance and consistent heat. Replace a faulty regulator to help regain correct flame height and reliable ignition. What it does:

• Regulates incoming gas pressure to the appliance's valves for consistent burner flames
• Commonly linked to low or weak flames, uneven burner heat, or burners that won't maintain a steady flame
• Helps the oven and burners reach and hold set temperatures when functioning correctly
• Works as part of the fuel delivery system between the supply line and appliance valves

• One pressure regulator (1 each)

• Turn off the gas supply and power to the appliance before starting any work
• Handle fittings carefully and use proper pipe-sealing materials where required by the appliance; avoid overtightening
• After installation, perform a gas leak test per local codes and manufacturer instructions

Oven won't light even with glowing igniter? Safety valve controls gas flow to burner. Moderately easy repair with gas line disconnect required.

Oven won't light or ignites with a loud pop? A faulty igniter is usually the cause. Simple DIY fix—disconnect two screws and wire nuts to replace.

Size: 8-18ab x 0.5 inch.

A replacement hex-head screw used to secure appliance regulator brackets and similar small components. Restores proper fastener fit so panels and brackets stay firmly attached. What it does

• Fastens regulator bracket and related sheet-metal components
• Provides a secure threaded connection for components where an 8-18 thread is specified
• Helps eliminate looseness or rattling caused by a missing or damaged screw
• Matches the nickel/chrome finish commonly used on interior mounting locations

• One hex head screw (8-18 x 3/8), nickel finish

• Intended for use where an 8-18 x 3/8 hex screw is specified by the manufacturer
• Tighten to snug; avoid over-torquing which can strip sheet-metal threads
• Turn off power to the appliance before accessing internal components
• If the original screw used a lock washer or threadlocker, replace or reapply as appropriate