Parts for Frigidaire TGB504CCB3: 03 - Burner Parts

Oven won't heat but igniter glows? This safety valve controls gas flow to the burner. Restores heating when valve fails to open or has a gas leak.

Oven won't light or ignites with a loud pop? A faulty igniter is usually the cause. Simple DIY fix—disconnect two screws and wire nuts to replace.

Support bracket that secures the safety valve in your oven. Replace if the mounting bracket is bent, cracked, or broken to properly reinstall the valve.

Mounting bracket that secures the safety valve in your oven. Replace this metal bracket if it's bent, broken, or missing to properly support the valve assembly.

This part has been discontinued by the manufacturer and is no longer available.

Thermal insulation that fits inside your oven door to retain heat and reduce exterior temperature. Replace if cracked, deteriorated, or missing.

Mounting screw for ranges, ovens, and cooktops. Secures panels, brackets, or internal components. Replace if missing, stripped, or damaged.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head