Parts for Ge GTD84ECPN1DG: Cabinet & Top Panel Parts

Fastens panels, brackets, and trim to appliance cabinets. Replace this screw when the original is missing, stripped, or damaged during service work.

Secures dryer panels and internal components to the cabinet frame. Replace if screw is stripped, missing, or loose to prevent vibration and rattling.

Size: 8-32 t. Includes 12 screws.

This Cover Top High Depth is an OEM part for GE dryers. It serves as a protective top cover for the dryer, designed to safeguard the internal components while adding to the overall aesthetic and structural integrity of the appliance. 

The need for a replacement top cover can arise from physical damage, wear, or aesthetic degradation over time. A damaged or missing top cover can leave internal components exposed and vulnerable to external elements, potentially affecting the dryer's functionality.

Symptoms of a bad Cover Top High Depth include:

• Visible damage or dents on the top cover.
• Misalignment or difficulty in fitting the cover onto the dryer.
• Unusual noises due to lack of proper insulation or vibration.
• Potential for dust and debris to enter the internal components.
• Decreased aesthetic appeal of the appliance.

This GE OEM replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
 

Genuine mounting screw that secures dryer panels, brackets, and trim pieces to the frame. Replace when stripped, missing, or worn to restore proper fit.

This fuse terminal cover shields and insulates the fuse connection inside your appliance, helping prevent accidental contact and shorting. Replace a cracked or missing cover to maintain safe electrical protection and dependable circuit performance.

• Covers and insulates the fuse terminals to protect the connection
• Helps prevent accidental contact, arcing, and debris intrusion at the fuse
• Common signs you need this part: missing cover, cracks, heat discoloration, or a cover that won't stay secured
• Promotes a secure, consistent fuse connection once installed

• Disconnect power at the breaker or unplug the appliance before servicing
• Access the fuse area per your service information; note wiring and cover orientation
• Remove the damaged cover; inspect terminals and wiring for heat damage or looseness
• Seat the new cover fully and verify it is secure and clear of wiring

Replacement strain relief bracket that secures the power cord at entry point. Needed when bracket is cracked, broken, or missing to restore safe cord routing.

The Water Valve is an OEM part for GE electric dryers. Located near the bottom of the machine, it controls water flow into the condenser system during moisture-sensing cycles.

The moisture sensing function uses this valve to introduce precise amounts of water vapor into the exhaust air stream periodically. This allows the condenser to capture moisture readings accurately and determine optimal cycle time based on humidity levels. 

Causes of failure include mineral buildup restricting flow, worn seals enabling leaks, or misaligned internal components hindering valve movement.

Symptoms of a faulty water valve are: 

• Loss of moisture sensing ability
• Incomplete or improper readings affecting cycle times  
• Water leaks from the valve area
• Failure to inject water vapor as needed

This part is also compatible with some Kenmore models using GE components.

Replace a faulty dryer wire harness if your dryer won't start, has intermittent power issues, or displays error codes. Moderate DIY repair in 1-2 hours.

Includes 12 screws. Size: 8-18 ab.