Parts for Frigidaire FAS185J2A8: 09 - Compressor Parts

Fix an air conditioner that won't cool or makes loud noises with this compressor. Advanced repair requiring refrigerant recovery and brazing skills.

Replace worn compressor mounting grommets to stop excessive vibration and noise. Fits most air conditioner and heat pump models. Simple DIY fix.

This terminal cover gasket seals and cushions the appliance's electrical terminal cover to help block dust and moisture while providing an insulating barrier around the power connection. It's a direct-fit replacement for worn or damaged seals. What it does:

• Seals the area around the terminal cover to help keep out dust, moisture, and debris
• Cushions and positions the terminal cover to reduce vibration and contact wear
• Provides electrical insulation around the terminal area for safer operation
• Commonly replaced when the cover is cracked, deformed, or no longer seals properly

• Disconnect power (unplug or shut off breaker) before servicing electrical terminals
• Remove the terminal cover per your model's service instructions, replace gasket, and re-seat cover fully
• Inspect terminal cover and wiring; replace any cracked covers or damaged wires before reassembly

This replacement terminal cover protects the appliance's power terminal block and wiring from accidental contact and debris, restoring a safe enclosure for the live electrical connections. What it does:

• Protects the terminal block and wiring from accidental contact, dust and debris
• Helps prevent arcing, sparks or shorting caused by exposed terminals
• Secures the routing area around power connections for safer operation
• Useful when original cover is cracked, melted, missing or shows burn marks

• Always disconnect power at the breaker or unplug the appliance before servicing
• Remove access panel or back panel to reach the terminal block; reinstall cover so it fully encloses the terminals
• Use appropriate fasteners if required; ensure all wire terminals are tight and positioned before replacing the cover
• If wiring or the terminal block shows damage or corrosion, replace or repair those components before restoring power

A replacement base stud assembly that secures the appliance chassis to its base, restoring stable support and proper alignment. Fits where a damaged or missing stud causes loose mounting or vibration. What it does

• Provides a secure mounting point between the appliance base and chassis to reduce movement and vibration
• Restores proper alignment when a worn or broken stud prevents panels or the base from seating correctly
• Helps eliminate rattling noises caused by loose or missing mounting hardware
• Used when visual damage, stripping, or corrosion prevents the original stud from holding fast

• High-level replacement; some disassembly of exterior panels may be required
• Disconnect power and/or water before servicing to ensure safety
• Keep track of removed fasteners and follow OEM diagram for correct reassembly
• Tighten to a snug fit; do not overtighten to avoid thread damage

Fix uneven cooling or system short cycling in your air conditioner with a new capillary tube. This 30-inch refrigerant line regulates flow between components. Moderate DIY repair.

Air conditioner not cooling properly or cycling on and off? A faulty sensor may be misreading temperature. This sensor helps restore accurate climate control.