Parts for Thermador KBUDT4255E/05: Compressor Parts

Removes contaminants and improves water taste in your refrigerator. Replace every six months for optimal performance. Confirm fit with your model number.

If your refrigerator motor runs erratically or stops working, this inverter control board manages variable motor speed for smooth operation.

If your refrigerator isn't cooling or runs constantly, the compressor may have failed. This part circulates refrigerant to maintain temperature.

Fix refrigerator electrical issues with this cable harness. Restores proper wiring connections for temperature control and lighting. Direct fit part.

This fan motor drives the blower assembly to move air for proper drying and ventilation performance. It restores airflow and can reduce noise or overheating caused by a failed blower motor. What it does:

• Spins the blower wheel to circulate air through the appliance
• Restores proper airflow for drying/venting cycles
• Can eliminate weak airflow, unusual fan noise, or overheating symptoms
• Works with the blower housing and associated fan controls

• Disconnect power before beginning any repair to avoid shock.
• Handle the motor and wiring harness carefully; avoid contaminating the motor shaft and connectors.
• Basic hand tools are usually required; follow the appliance service manual for correct disassembly/reassembly.

Fix refrigerator electrical issues with this cable harness. Connects control boards and components. Typical DIY repair takes 30-45 minutes.

This sealing strip forms the door gasket that helps keep water and heat inside the appliance, restoring a tight seal for reliable operation and reducing leaks and drafts. What it does

• Replaces a worn or damaged door gasket to restore a secure edge seal
• Helps stop water leaks and prevents moisture from escaping around the door
• Reduces drafts, rattling, and poor door closure caused by degraded seals
• Restores proper sealing to improve appliance efficiency and performance

• Disconnect power and shut off water before beginning any repair.
• Remove the old gasket carefully to avoid damaging surrounding trim; align the new strip fully into the door channel.
• Only trim or modify the gasket if your model's service instructions explicitly allow it.