Parts for Thermador PDR364GDZS/08: Control Panel / Knobs / Thermostat Parts

Fix blank screens, unresponsive controls, or error codes with this display control interface. Restores visible feedback and menu settings for your cooktop.

Gas range fixing kit secures components and prevents rattling or loosening. Replace when parts become loose or unstable. Verify fit with your model number.

Indicator light for gas ranges and cooktops. Replace when light burns out or fails to illuminate. Verify fit with your model number before ordering.

The Spark Ignition Switch is an OEM part for Bosch ranges and cooktops. It controls the ignition of surface burner flames by emitting an electrical spark when activated.

Causes of a bad switch can be general wear and fatigue over thousands of start cycles. Exposure to moisture, dust or metal debris could also damage electrical components internally.

Symptoms of a bad spark ignition switch include:

• Burners failing to light even when valves are turned on
• Intermittent or irregular lighting of some burners
• No electrical sparks emitted from the ignition electrode

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This rotary potentiometer converts shaft rotation into an electrical signal the control board can read, providing precise position feedback for user selections. Replace it if inputs become erratic, jump between settings, or the control stops responding.

• Provides rotary position feedback to the electronic control
• Enables accurate selection and adjustment of functions or setpoints
• Wear or damage can cause drifting, dead spots, or incorrect readings
• Intermittent or no response to input is a common failure symptom

• Disconnect power before servicing
• Access the control/console area to reach the component
• Note shaft orientation and any connector positions; transfer exactly to the new part
• Handle electronics with ESD care and verify smooth, full-range operation after reassembly

Mounting hardware kit for gas ranges. Secures panels, brackets, and assemblies in place. Replace if screws, bolts, or fasteners are missing or stripped.

Fixes burner not getting gas or won't ignite. Solenoid valve controls gas flow to individual burners. Moderate DIY repair for gas ranges and cooktops.

Replacement selector knob for your range. Fits onto the control shaft to select functions, cycles, or heat levels. Needed when original is cracked, broken, or missing.

Replace a cracked or missing spacer for your gas range. This small structural component helps maintain proper spacing between parts during installation.

Black slimline control knob for your range. Installs on the control panel to replace worn, cracked, stripped, or missing knobs and restore secure grip.

Replacement control knob for range griddle burner. Installs on the control panel. Order if your original knob is cracked, broken, or missing.

Fix erratic temperature readings or a stuck display on your range. This temperature display assembly restores clear temperature readouts and control feedback.

Replace your cracked or missing range oven control knob. This slimline large knob installs on the control panel to operate oven functions. Ideal for worn or broken knobs.

This slimline standard control knob replaces a worn, cracked, or missing front-panel knob to restore reliable control and a clean appearance. It fits slim-profile control shafts and matches factory styling. What it does:

• Replaces a stripped, broken, or missing control knob so you can operate the appliance again.
• Provides a secure push-on fit to the control shaft for accurate selection of settings.
• Restores original appearance on slimline control panels for a neat finish.
• Works as a direct-fit user interface part—no electronic changes required.

• One replacement slimline standard control knob.

• Typically installs with a simple push-on or pull-off action; inspect the control shaft for damage before installing.
• Disconnect power to the appliance before servicing to avoid injury.
• If knob does not seat smoothly, do not force—verify shaft type and alignment.