Parts for Frigidaire FDB2321REC0: 03 - Control Panel Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Replace your dishwasher's cover if it's cracked, broken, or missing. This protective cover installs to conceal and protect internal components.

Replacement vent adapter for your dishwasher. Connects ventilation components to ensure proper airflow. Order a new adapter if yours is cracked or damaged.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

This is a replacement Energy Guide label that restores the original energy-use and efficiency information on your appliance. It provides the visible markings required for reference and resale value. What it does:

• Replaces a missing, damaged, or faded Energy Guide label so energy information is legible.
• Restores factory identification and energy-consumption details typically found on the appliance.
• Helps satisfy resale or inspection expectations by supplying the correct on-appliance label.
• Improves usability by making the official energy ratings easy to read at a glance.

• Clean and dry the mounting surface before applying; remove old adhesive residue for best adhesion.
• Align the label carefully, then press firmly to ensure full contact; do not stretch or fold the label.
• For best results, apply at room temperature and avoid repositioning once adhered.
• This is a cosmetic/informational part only; no electrical work is required to install.

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

6 - 10 x 3/8, pan plask, switch

Replacement mounting screw for dishwasher panels and components. Secures loose panels, brackets, and trim. Needed when original fasteners are missing, stripped, or worn.

Replace your dishwasher door gasket to restore the watertight seal that prevents leaks and ensures proper cleaning. Install when worn or damaged.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

The Side Mount Kit is an OEM replacement part for Frigidaire dishwashers. It contains mounting brackets, screws, and other hardware required to securely install the dishwasher against cabinetry in a side-by-side configuration. Proper attachment is necessary for stability and safety during operation. 

Symptoms of damaged or missing mounting hardware include:

• Excessive movement or rocking of the dishwasher body
• Potential detachment from cabinets  
• Screws pulling loose from repeated vibrations
• Improper door alignment causing difficulty closing fully

Causes related to normal wear over extended use periods. Damage may occur if weight is applied during improper lifting or installation attempts.  

Compatible models include Electrolux, Gibson, and select Kenmore units.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.