Parts for Kitchenaid KODE900HSS20: Control Panel Parts

Replaces the control panel overlay on your microwave or wall oven. Installs over the control board. Needed when graphics are worn or faded.

Stainless steel control panel overlay for built-in ovens and microwaves. Replaces cracked, scratched, or discolored overlays to restore appearance.

Wall oven not responding to buttons or won't start? This electronic control board manages all functions and settings. Moderate repair complexity.

The Whirlpool screw is an OEM replacement part responsible for securing various components or parts on different types of Whirlpool appliances. The screw is designed to provide a secure and reliable fastening connection, ensuring that different parts of the appliance stay in place. It is commonly used in different locations within the appliance, such as the cabinet, panels, or other structural elements.

This part fixes the following symptoms:

• Loose or wobbly components within the appliance
• Panels or parts that are not securely attached
• Rattling or unusual noises due to loose parts
• Damaged or missing screw

The Whirlpool screw can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

This foam seal fits between mating parts to create a tight barrier that helps prevent leaks and rattling. Replacing a worn or missing seal restores proper sealing and helps keep your appliance running quietly. What it does:

• Creates a compliant gasket between components to limit air or moisture passage
• Helps dampen vibration and reduce rattling/buzzing where parts meet
• Helps maintain proper airflow or fluid routing as designed
• Typical symptoms include leaks, condensation/frost near a joint, or new vibration noises

• One foam seal

• Disconnect power; turn off the water supply before service
• Note the original seal's routing/orientation before removal
• Clean and dry all mating surfaces; remove old foam and residue
• Install without stretching or over-compressing; ensure even contact with no gaps

Wall oven display not turning on or buttons not responding? This electronic control board assembly restores cycle selection and timed functions.

This wire harness is a factory-style main wiring assembly that delivers power and control signals between the appliance control and internal components, restoring proper electrical connections for reliable operation. What it does

• Carries power and control signals between the control board and motors, valves, heaters, sensors, or switches.
• Replaces damaged or frayed wiring that can cause intermittent operation or loss of function.
• Restores proper connector fit and routing to prevent shorts or connector overheating.
• Helps address symptoms like non-starting cycles, unresponsive controls, or components that do not run.

• Disconnect all power (unplug or shut off breaker) before starting any repair.
• Note or photograph the original routing and connector positions to ensure correct reinstallation.
• Disconnect and reconnect all connectors fully; avoid pulling on wires—use connector bodies.
• Inspect mating connectors and mounting points for damage before powering the appliance; test operation after reassembly.

This mounting bracket is a replacement support bracket that secures appliance components and keeps assemblies aligned for reliable operation. It restores proper fit and helps prevent rattling or movement from loose fittings. What it does:

• Secures panels or assemblies to the appliance frame to maintain proper alignment
• Reduces vibration and rattling caused by loose or damaged supports
• Restores mounting points that prevent sagging or separation of connected parts
• Helps ensure stable operation after repairs involving removed or replaced hardware

• Follow the appliance service manual for exact location and fastener torque
• Disconnect power (and gas if applicable) before beginning any repair
• Use appropriate tools and replace any damaged screws or clips with OEM-equivalent fasteners