Parts for Admiral JS2628HEHB / PJS2628HHB0: 02 - Controls Parts

Replace your refrigerator water filter every 6 months to ensure clean, fresh-tasting water and ice. Easy twist-on installation. Verify fit with your model.

Damper insulation for side-by-side refrigerators. Installs around the air damper assembly. Replace if worn, cracked, or missing to restore proper fit.

This replacement screw secures panels, brackets, and components inside appliances. Replacing a missing or stripped fastener restores a snug, rattle-free fit using the correct #8-18 thread and 5/8-inch length.

• Fastens covers, trims, brackets, and internal parts to the cabinet/frame
• Used wherever a #8-18 x 5/8 screw is specified
• Replace if the original is missing, corroded, stripped, or will not tighten
• Symptoms: loose or rattling panels, gaps, or hardware that backs out

• Disconnect power; shut off gas/water before servicing
• Match thread and length; start by hand to avoid cross-threading
• Use the correct driver bit and tighten snugly—do not overtighten
• Inspect and replace damaged clips or tabs before securing

This thermistor is the refrigerator temperature sensor that monitors internal air temperature and helps the control board regulate cooling for safe food storage. It replaces a failed sensor to restore accurate temperature readings and normal cycling. What it does:

• Senses refrigerator/freezer air temperature so the control board can adjust compressor and fan operation
• Can cause improper cooling or erratic cycling when faulty (too warm, too cold, or constant running)
• Helps the appliance respond correctly to user temperature settings and defrost cycles
• Works as part of the temperature control system; not a standalone control module

• Disconnect power to the appliance before beginning any service to avoid shock or injury.
• Handle the sensor tip and wiring gently; avoid kinking or damaging the harness.
• Verify correct connector alignment and secure fit to the harness; test operation after installation.