Parts for Bosch B22CT80SNP/01: Door Assembly Parts

Replacement mounting screw for refrigerator panels, brackets, and trim assemblies. Needed when original fastener is missing, stripped, or damaged.

This door seal forms a tight barrier between the dishwasher door and tub to contain wash water and steam. Replacing a worn gasket restores a proper seal to help prevent leaks and maintain efficient wash performance. What it does:

• Creates a watertight seal between the tub opening and door during wash and rinse cycles
• Helps keep water, suds, and steam from escaping at the sides and top of the door
• Common symptoms: water on the floor at the front corners, drips down the door, visible cracks/flattening of the gasket, door not closing snugly
• Can reduce moisture and noise escaping while the dishwasher runs

• 1 door seal

• Disconnect power and turn off the water supply before servicing
• Open the door, pull the old seal straight out of the channel; clean the groove of debris and mineral buildup
• Warm the new seal in hot water to relax it; press it evenly into the channel without stretching, centering at the top
• Close the door to seat the gasket and check for even compression around the perimeter

This dividing wall is an interior tub divider designed to separate and support loading areas inside the appliance, helping maintain proper spray and drying performance. It replaces damaged or missing dividers to restore proper internal separation. What it does:

• Recreates the intended interior separation between tub sections to keep racks and items properly positioned
• Helps maintain correct water flow and spray coverage by restoring the tub's original geometry
• Prevents items from shifting into adjacent compartments during cycles
• Addresses symptoms such as rattling or items falling between compartments and visible damage or missing trim

• Inspect surrounding clips and mounting points; replace any broken hardware before installing
• Turn off power and water to the appliance and follow manufacturer service instructions before beginning work
• Use basic hand tools; avoid forcing parts to prevent cracking plastic components