Parts for Bosch HBN3550UC/11: Door Lower Parts

Fix a damaged or worn oven door interior with this inner door panel. Restores structural support, provides mounting for hardware, and protects components.

Replace your wall oven door seal gasket to restore airtight closure and prevent heat loss. Maintains proper sealing for efficient cooking. Confirm fit by model.

Replacement outer glass panel for wall oven doors. Installs on the exterior door surface. Needed when the original glass is cracked, chipped, or shattered.

This is the dishwasher door frame that supports the door assembly and trim, restoring the door's fit and appearance. It replaces a damaged or bent frame to help the door close securely and sit flush. What it does:

• Forms the structural border of the dishwasher door, holding inner panels and trim in place
• Helps maintain correct door alignment and sealing for proper closing
• Addresses symptoms like a warped or dented door edge, loose trim, or visible damage
• Works with existing latch and hinge components when installed correctly

• One dishwasher door frame

• Door may need to be removed for access
• Keep track of screws and trim clips; reuse original fasteners unless replacements are provided
• Disconnect power and water to the appliance and follow safety precautions before starting
• Minor adjustments to alignment may be necessary after installation to ensure proper sealing

Replacement glass panel for wall oven control and display area. Restores protection and clean appearance when original is cracked, broken, or scratched.

Replacement washer for electric wall ovens. Installs between components to provide secure spacing and prevent wear. Order if original is missing, damaged, or worn.

This metal mounting bracket secures internal components and panels to restore proper alignment and reduce rattling. It's a straightforward replacement part that helps keep appliance panels and assemblies firmly in place for reliable operation. What it does:

• Provides a secure attachment point for panels or internal assemblies to prevent movement and vibration
• Helps correct alignment issues that can cause rubbing, gaps, or noise
• Restores the original fit where a bent, cracked, or missing bracket caused loose parts
• Works with the appliance's existing fasteners and mounting points

• Remove power and, if applicable, disconnect the appliance from water before beginning work
• Use the factory fasteners or OEM replacement screws to secure the bracket in the original location
• Verify alignment of the attached panel or assembly before fully tightening fasteners

Replace your wall oven's broken or snapped door bracket. This mounting bracket secures the lower oven door panel and attaches door clips for proper alignment.

Retainer clip secures wiring harnesses and hoses inside your wall oven. Replace if broken, missing, or worn to prevent internal component movement.

Protective cap seals exposed openings on wall ovens to prevent dirt and moisture damage. Replace if cracked, missing, or loose. Verify fit with model number.

Replacement door handle for wall ovens. Installs on the outer door panel to provide grip for opening and closing. Order when original is cracked or broken.

Replacement spacer for electric wall ovens. Maintains proper clearance and alignment between oven components. Order if original is cracked or missing.

Mounting screw for electric and gas ranges and wall ovens. Secures internal components and panels. Replace if missing, stripped, or damaged during repair.