Parts for Bosch SHX9PT75UC/C9: Door Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Dispenser door won't open or stay closed? This dishwasher dispenser releases detergent and rinse aid at the right time. Moderate DIY repair.

Detergent releasing too early or leaking from the dispenser? This seal creates a watertight barrier to prevent premature dissolution. Easy 10-minute fix.

Fix incomplete cycles or poor cleaning caused by a faulty temperature sensor. This NTC sensor monitors water temperature to ensure proper heating and cycle timing.

Rinse aid leaking or sticky dishes? This dispenser lid seals the rinse aid compartment. Quick 2-minute snap-in replacement fixes leaks and residue issues.

Replace your broken or cracked dishwasher detergent dispenser door lid. This cover installs on the dispenser compartment to keep detergent secure.

Fix a warped or damaged dishwasher door with this inner door panel. Restores proper door fit, stops leaks and rattling. Moderate DIY repair.

This replacement screw secures panels, brackets, and internal parts in your appliance for a tight, rattle-free fit. Use it to replace lost, stripped, or corroded hardware and keep components properly fastened.

• Fastens components to the appliance frame or assemblies
• Replaces a missing, stripped, or rusted original screw
• Helps reduce rattling or vibration from loose hardware
• Restores proper alignment of panels or brackets

• Disconnect power and shut off water before servicing
• Refer to your model's parts diagram to locate and place
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening

Six-screw kit for securing the inner door assembly in your dishwasher. Replace missing, stripped, or lost screws to properly fasten door panels.

Dishwasher door seal creates a watertight barrier around the tub opening. Replace if you notice leaks, moisture escaping, or visible cracks. Confirm fit with your model number.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Replacement screw for dishwashers. Secures panels and internal components. Needed when original is stripped, missing, or damaged during repairs.

Insulating plate for dishwasher door assembly. Installs between panels to provide thermal protection. Replace if cracked, warped, or missing.

Outer door panel for your dishwasher. Replace if cracked, dented, discolored, or damaged. Covers the front exterior of the dishwasher door.

This insulating plate serves as the microwave's waveguide cover. It shields the waveguide opening from steam and splatter while allowing energy to enter the cavity, helping prevent arcing and protecting internal components and cavity surfaces.

• Shields the waveguide/magnetron opening from grease and moisture
• Electrically insulates the feed area to reduce arcing
• Helps maintain proper microwave energy distribution into the cavity
• Common signs of failure: sparking from the side wall, burn marks on the cover, sizzling/burning odor during cooking, or a visibly cracked/charred plate

• Disconnect power before servicing; never operate the microwave without this cover installed
• Remove the retaining screw or release tabs, note orientation, and seat the new plate flush over the waveguide opening
• If arcing occurred, clean any carbonized residue from the cavity surface before installing the replacement

The Door Handle is an OEM part for Bosch dishwashers. It is installed on the outer edge of the dishwasher door and is used to open and close the door.

The door handle is responsible for providing an easy and secure grip point to facilitate loading and unloading of dishes. It allows for controlled movement of the door through its range of motion.

Symptoms of a bad door handle can include:

• Looseness, wobbling, or detachment from the door
• Chipping, cracking or general wear and tear of the handle surface
• Difficulty grasping or lifting the door with the handle
• The door failing to securely latch in the closed position

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Broken or missing dishwasher handle end cap? This finishing piece covers handle ends for a complete look. DIY repair in 15-30 minutes with basic tools.

Secures panels, brackets, and internal components in your dishwasher. Replace this screw if it's stripped, missing, or corroded to restore proper fit.

Hardware washer distributes clamping force under screws and nuts in your dishwasher. Replace when worn or missing to restore secure fit and reduce vibration.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.