Parts for Frigidaire FGIH3047VFA: Door Parts

Replaces perimeter trim on range door to restore clean appearance and secure fit. Needed when original trim is cracked, warped, discolored, or missing.

Note: Per factory, the glass no longer has the foil tape.

The Outer Door Glass is an OEM part for Frigidaire ranges. As the outermost barrier protecting the interior of the oven, the door glass is subject to wear, scratches, and impact damage through regular use. Made of durable heat-resistant tempered glass, this OEM replacement part ensures your oven door retains its integrity.

Causes of a bad door glass can include small chips or cracks that develop from regular cleaning or use over time. Larger cracks or breaks are often caused by impact or mishandling.

Symptoms of a bad door glass include:

• Cracks or chips that compromise the structural integrity of the glass
• Increased heat loss from the oven when in use
• Inability to properly seal the oven door
• Possible injury risks from broken or damaged glass

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Replacement shield that protects internal range components from damage. Install this cover if your original is cracked, broken, or missing to keep panels secure.

This refrigerator cabinet insulation panel helps keep cold in and heat out to improve cooling consistency and efficiency. It replaces damaged or missing insulation to reduce frost, hot spots, and excess compressor run time. What it does:

• Provides thermal barrier between the cabinet and outer shell to retain cold air
• Helps reduce frost buildup and condensation inside the cabinet
• Can improve cooling performance and reduce excessive compressor cycling
• Dampens vibration and reduces operating noise

• Disconnect power and empty the appliance before beginning any repair
• Remove interior panels or shelves as needed to access the insulation; follow model-specific service instructions
• Handle insulation carefully to avoid tearing; use gloves and eye protection when trimming or repositioning
• If adhesive or clips are damaged, replace with OEM fasteners

Insulation panel installs inside the range cabinet to provide thermal barrier and sound dampening. Replace if cracked, worn, or missing for proper fit.

Inner door glass panel for range and wall oven doors. Replace if cracked, shattered, or slipped out of position. Installs between outer glass and oven cavity.

Mounting screw for electric and gas ranges. Secures panels, brackets, and internal components. Replace if screw is stripped, missing, or broken.

Replace your range oven door gasket to prevent heat escape and maintain proper temperature. Snaps into place with embedded clips. Confirm fit by model.

Replace your range oven door hinge to restore proper door alignment and smooth operation. Fixes door sag and improves seal. Verify fit with your model.

Replace your range's oven door handle if it's cracked, broken, or worn. This structural component mounts to the oven door for opening and closing access.

This replacement door cap is the molded end cap that finishes and protects the edge of a refrigerator door, restoring a clean appearance and covering exposed hardware. It helps keep the door trim sealed and cosmetically intact. What it does

• Covers and protects the exposed door edge and hinge area from damage and wear
• Restores a finished, factory appearance when the original cap is cracked or missing
• Helps prevent dirt and moisture from collecting in the exposed trim area
• Reduces rubbing or misalignment caused by damaged door trim

• One door cap/end cap

• High-level, snap-on or screw-retained installation; follow the manufacturer's diagram for the correct orientation
• Remove the door or hinge only if required by the manufacturer's instructions
• Disconnect power to the appliance before working near electrical components or removing door-mounted controls
• Use basic hand tools and take care not to scratch painted surfaces during installation

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.

Replacement screw secures panels, trim, and internal components in your appliance. Needed when original fastener is missing, stripped, or damaged.