Parts for Kenmore 911.41489995 (91141489995, 911 41489995): Door Parts

Seals oven door to retain heat and prevent smoke or steam from escaping. Replace when frayed, cracked, or no longer forming a tight seal. Easy install.

Replace worn felt pads that cushion your range door and prevent rattling or gaps. Essential when door closes unevenly or makes noise. Confirm fit with model.

Seals and cushions your oven door to reduce vibration and rattling. Replace when worn to restore proper spacing and eliminate air leaks. Verify fit.

Door pad gasket creates a seal between your oven door and front panel. Replace if worn, cracked, or causing heat loss. Confirm fit with your model number.

Reinforcement plate restores structural support where the oven door or trim attaches. Replaces cracked or broken plates to stop sagging and keep panels aligned.

Oven door glass window pack for viewing food while cooking. Replaces cracked, shattered, or broken glass. Installs inside the oven door frame assembly.

Secures your oven door glass and trim for proper alignment and quiet operation. Replace when clips are cracked, broken, or missing. Verify fit with your model.

Hex washer head screw secures oven panels, brackets, and door handles. Replace missing, stripped, or damaged screws to eliminate looseness and rattling.

ST10-16 X 7/16"

White screw secures panels and trim on ovens and ranges. Replace stripped, corroded, or missing fasteners to restore proper fit and stop rattles.

Replacement screw for securing oven components, panels, and brackets. Restores tight mounting when original screws are missing, stripped, or lost.

This is a flat-head screw used to secure panels and components in compatible appliances. It provides a flush finish and reliable fastening for trim, interior panels, and small assemblies. What it does:

• Fastens trim, brackets, and small appliance components with a flat, countersunk head
• Provides a flush surface to prevent snagging and keep panels aligned
• Commonly used where a low-profile finish is needed for aesthetics and clearance

• One screw

• Use the matching Phillips or screwdriver bit; avoid over-tightening to prevent stripping
• Inspect mating threads and replace if damaged; use correct screw length to avoid puncturing internal components
• Disconnect power or follow appliance safety procedures before servicing

Secures the igniter to the burner assembly in gas ranges and ovens. Replace if stripped, missing, or damaged during igniter replacement or repair.

Black. 8-18 AB HXW 3/8