Parts for Husqvarna 917287560: Electrical Parts

Greaseable blade spindle assembly for riding mower decks. Mounts to the underside of the mower deck and holds the cutting blade. Replace if cracked, worn, or damaged.

If your riding mower won't start unless the brake is engaged or starts in unsafe conditions, the interlock safety switch may have failed. Direct replacement.

Replace your lawn tractor's wire harness assembly if the engine won't start, electrical components fail, or wiring is damaged. Connects engine parts for proper operation.

Fix a riding mower that won't start or has no electrical power with this protective fuse. Simple 5-minute replacement prevents electrical damage.

Mower won't start unless seated? This seat safety switch prevents operation when the operator leaves the seat. Simple swap-out repair for most DIYers.

Mower won't start or starter doesn't engage? This ignition switch activates your riding mower's electrical system. Simple DIY repair in under 30 minutes.

Chassis wiring harness for riding lawn tractors. Replaces damaged, frayed, or corroded wire harnesses. Essential when existing harness is broken or worn.

The starter solenoid, also called a starter relay, is a low-amperage relay that completes the high-amperage connection between the starter motor and the battery when the ignition key is turned. The starter solenoid is needed to engage the starter motor. When the ignition is turned on, the battery sends a small electrical charge to the starter solenoid. The solenoid shuts a switch, so a more significant amount of current is sent to the starter motor. The starter motor shaft starts to rotate and engage the teeth of the flywheel. The flywheel then turns the crankshaft to put the engine in motion. A bad solenoid can deny the flow of electricity to the starter motor and prevent engine startup. However, other underlying problems may also exist. The battery may be in good condition, but the engine is not cranking, or clicking and grinding noises may come from the solenoid. These are signs that the starter solenoid should be replaced. This starter solenoid is for use in riding lawn tractors and zero-turn riding mowers. It is compatible with specific models from different brands, including Ariens, Craftsman, Dixon, Husqvarna, Hyper Tough, Jonsered, Murray, Poulan Pro, Redmax, and Snapper. It is a genuine OEM replacement part sourced directly from the manufacturer and is sold individually.

Indicator meter not displaying properly or reading incorrectly? Replace this meter to restore accurate monitoring of your mower's systems. Simple install.

Mower blades won't engage or disengage? This PTO switch controls blade engagement from your console. Direct replacement restores safe cutting control.

This screw is a genuine Husqvarna part, sold individually. This screw can be used as a replacement part in a lawn mower or a snowblower. The purpose of the screw in a lawn mower or a snowblower is to serve as a fastening component.The screw in a lawn mower or a snowblower might need to be replaced if the screw is chipped away, eroded, dented, punctured, or scraped at some point within the typical lifespan of the appliance. The screw can also be lost or misplaced during the operation of the appliance, in which case the screw should be replaced by this genuine OEM replacement part.This component is a genuine OEM replacement part sourced directly from the manufacturer. It is sold individually. This screw is compatible with the following outdoor appliance brands: Husqvarna, Craftsman, Weed Eater, Poulan, Murray, Ariens, and Dixon.

Ignition harness wire assembly for lawn tractors and riding mowers. Connects ignition components to enable engine start/stop. Replace if cracked or worn.

Battery mounting strap for riding mowers and lawn tractors. Secures battery in place at the front mount position. Replace if cracked, broken, or missing.

Wiring harness pigtail connector for lawn tractors and riding mowers. Replace this electrical connector if damaged, corroded, or melted wires prevent proper connections.