Electrolux Dishwasher Switch

Fix i20 or i30 error codes with this dishwasher pressure sensor. Monitors water pressure to prevent overfilling. Common DIY repair for continuous filling.

Fixes dishwasher leaking, error code i20, or pump that won't stop running. Monitors water pressure to control wash cycles. DIY-friendly repair.

This switch assembly restores electrical on/off control for a specific appliance function. Replace a worn or failed switch to stop intermittent operation and return reliable control to the affected circuit. What it does:

• Provides the electrical on/off or function control for the appliance circuit.
• Replaces a failed switch that can cause intermittent operation or unresponsive controls.
• Helps resolve symptoms such as a function that won't start, no response from the control, or erratic switching.
• Connects to the existing wiring harness and mates with the original mounting points.

• Disconnect power to the appliance before beginning any work.
• Remove the appropriate access panel to reach the switch; note wire and terminal locations before disconnecting.
• Unplug the wiring harness or carefully detach terminals, swap the switch assembly, then reconnect securely.
• Restore power and verify the replaced switch operates the function correctly.

Dishwasher door won't start cycles or stops mid-wash? This door-mounted switch detects when the door is open and controls operation. Easy DIY fix.

Dishwasher not starting or cycles not changing? This switch assembly restores electrical control for on/off and cycle selection. Direct replacement.

This float assembly helps detect and control water level inside the appliance to prevent overfilling and enable normal drain cycles. It replaces a worn or stuck float to restore reliable water sensing and operation. What it does:

• Rises with water level to trigger the appliance's water-level detection system
• Helps stop overfilling and reduces risk of leaks or continuous fill
• Commonly related to symptoms like persistent fill, frequent draining, or error codes tied to water level
• Works as the mechanical sensing element in the water management system

• One float assembly

• Disconnect power and water supply before starting any repair
• Verify correct alignment and free movement of the float after installation
• Reassemble panels and run a short test cycle to confirm proper operation