Parts for Thermador T36IT71NNP/01: Frames Parts

This active carbon filter refreshes the air when your range hood is set to recirculate. Replace a saturated filter to restore effective odor reduction and maintain a more comfortable cooking space. What it does:

• Adsorbs cooking odors in recirculating operation
• Helps maintain fresher indoor air when venting back into the room
• Restores odor-removal performance when the old filter is saturated
• Typical signs it's time to replace: persistent cooking smells or diminished odor reduction

• One activated carbon filter

• Disconnect power to the hood before servicing
• Remove the metal grease filter(s) to access the charcoal filter
• Release the old filter from its clips/bayonet mount and install the new filter in the same orientation until it locks
• Charcoal filters are not washable; replace when saturated

• For hoods configured for recirculation; not used when vented to the outdoors

Removes impurities from your refrigerator's water and ice supply. Replace every 6 months for clean, fresh-tasting water. Verify fit by model number.

This fixture is the replacement mounting component used to secure internal parts and assemblies in place, restoring proper alignment and reducing rattles or movement. It's a direct-fit replacement when the original fixture is cracked or missing. What it does

• Secures and supports nearby panels or internal components to maintain correct alignment.
• Prevents rubbing, vibration noise, and misalignment caused by a broken or missing fixture.
• Helps maintain the appliance's intended fit-and-function of adjacent parts.
• Use when visual damage, looseness, or part migration is observed.

• One fixture component

• Turn power off and disconnect the appliance before beginning any repair.
• Access the location via the appropriate panel or assembly; retain screws and fasteners for reassembly.
• Replace only the damaged fixture and verify adjacent parts are not worn.

Exterior trim piece that finishes the refrigerator door edge. Replaces scratched, peeling, or missing stripe to restore cosmetic appearance.

Replacement door trim strip that restores the finished appearance of your refrigerator door. Replaces worn, cracked, missing, or scratched trim pieces.

Decorative stripe trim that mounts on refrigerator door exterior. Replace when cracked, peeling, discolored, or missing to restore appearance.

Retaining pin secures hinges, panels, and linkages in your refrigerator or freezer. Replace if pin is missing, bent, or worn to restore alignment.

Replace a cracked or broken support bracket in your refrigerator. This structural component provides stability and mounting support for internal parts.

Sheet panel for bottom-mount refrigerators. Installs as an interior structural component. Replace if cracked, warped, or damaged during service.

Decorative trim stripe for refrigerator side panels. Replaces cracked, peeling, or missing exterior accent strips. Restores clean appearance.

Decorative stripe trim for refrigerator doors. Installs along the door edge to provide a finished appearance. Replace if cracked, peeling, or missing.

Replace your refrigerator's compartment lid cover if cracked, broken, or missing. This lid installs in the fresh food section to cover storage bins.

Exterior trim piece that finishes the refrigerator door edge. Replaces scratched, peeling, or missing stripe to restore cosmetic appearance.

A decorative profile stripe that restores the appliance's finished appearance and covers the cabinet edge. Replaces a worn, cracked, or missing trim piece to improve the look of the unit. What it does

• Provides the exterior trim/edge cover that completes the appliance front
• Hides gaps between panels and creates a smooth, finished appearance
• Commonly replaced when the stripe is cracked, peeled, scratched, or missing
• Helps prevent dirt and moisture from collecting in exposed seams

• One profile stripe decorative trim piece as shown

• Generally installs by snapping or sliding into place; follow your model's service instructions
• Clean mating surfaces and remove adhesive residue before installation for best fit
• Handle carefully to avoid scratching the finish during installation