Parts for Ge GFE28GELHDS: Freezer Section Parts

Circulates cold air in your freezer to maintain consistent temperature and prevent frost buildup. Replace if freezer isn't cooling or fan stops running.

Secures evaporator thermistor to tubing for accurate temperature readings. Replace if broken or missing to restore proper cooling and defrost cycles. Confirm fit.

Fix refrigerator not cooling or freezing issues with this freezer evaporator coil assembly. Includes defrost heater. Moderate DIY repair, 1-2 hours.

Fix frost buildup and ice accumulation in your freezer. This defrost heater melts frost from the evaporator coils during defrost cycles to restore cooling.

Excess frost in freezer? This evaporator block seal prevents moist air from reaching cold components, reducing frost buildup and improving efficiency.

Freezer thawing or frost building up inside? This defrost thermostat monitors coil temperature during defrost cycles. Easy DIY fix with video guide.

Fix frost buildup in your freezer with this defrost heater harness and thermostat. Restores proper defrost cycling to prevent ice accumulation.

Fixes excessive frost buildup in freezer. This defrost heater melts ice from evaporator coils to restore cooling efficiency. Includes installation video.

Cushions and seals mating parts in your refrigerator to reduce vibration and squeaks. Replace worn tape to restore quiet operation and secure fits.

Fix water pooling or ice buildup in your freezer with this trough drain. Channels defrost water to the drain tube, preventing frost accumulation issues.

Plastic cover that mounts over the freezer fan and vent area. Replace if cracked, broken, or missing to restore proper airflow protection.

Fix uneven cooling or defrost issues with a new temperature sensor. Most DIYers complete this repair in under an hour with basic tools and our video.

This holder element assembly secures the appliance's heating element in the correct position so the element stays stable for consistent operation and safe performance. It's a direct-fit replacement for worn or damaged holders. What it does:

• Secures and supports the heating element inside the appliance to maintain proper alignment
• Prevents element sagging or contact with other components that can cause noise or arcing
• Helps reduce vibration and movement that can lead to intermittent heating
• Common symptom: visible holder damage, loose or shifted element, unusual noise during operation

• Disconnect power (unplug or switch off breaker) before starting any repair
• Allow appliance and element to fully cool before handling
• Handle the element and holder carefully to avoid bending or damaging the element

Fixes uneven cooling or frost buildup caused by a misaligned defrost heater. This holder assembly secures the element in place. 15-minute repair.