Kenneth S Lindenhurst , IL March 08, 2017 Loud whirring noise on spin cycle Replaced transmission and support assembly. Hub nut corrode on support, spanner wrench would not loosen. Had to use 1 11/16 deep socket and impact wrench to remove, basket would not com off support even after cleaning out and soaking with penetrant and using automotive air hammer to push out. I had to cut support plate in half with die grinder, cut bearing from shaft and punch out agitator shaft then use die grinder with carbide burr to cut basket shaft in two before basket would come off shaft. I am an experienced automotive technician with 40+ years and this job is not for the average DYIer if the nut and basket look corroded after removing the agitator Read More... 25 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Screwdrivers, Socket Set, Wrench Set
James I Castleton , VT November 08, 2015 Appliance: Model GTUN275EM1 GE WASHER DRYER COMBO Water leaking from tub seal Researched issue online. Took apart wash machine. Had to use car jack and 2x4 to seperate tub from tub seal and transmission. Worked great. Reassembled motor to new transmission and tub seal. Machine is quieter and does not leak. Directions and videos helped but not all I referred too were specific to my model. Good luck Read More... 14 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set