General Electric Washer Dryer Combo Bumper, Bushing, Grommet Parts

Plastic socket that holds the suspension rod ball in your washer. Replace if worn, cracked, or deformed to restore proper tub support and alignment.

This lid bumper cushions the lid of your top-load washer as it closes, absorbing impact to reduce slamming noise and protect the top panel's finish. Replace a worn or missing bumper to restore smooth, quiet lid operation. What it does

• Absorbs impact between the lid and cabinet to reduce slamming and vibration noise
• Helps protect the top panel finish from chips and scratches near the lid area
• Restores proper cushioning when the original bumper is missing, cracked, or flattened
• Common symptoms: lid slams or clunks when closing, increased noise, visible missing bumper

• 1 lid bumper

• Disconnect power before servicing
• Open the lid and pull the old bumper straight out of its mounting hole; needle-nose pliers can help if it's stuck
• Clean the hole and surrounding surface for a secure fit
• Press the new bumper fully into the hole until seated flush; for even cushioning, consider replacing both if your model uses two

Replacement door hinge bushing for laundry centers. Restores smooth pivot operation when original is worn, cracked, or causes door misalignment or sticking.

Plastic cup that holds the suspension rod at the tub connection point. Replace if cracked, worn, or broken to restore proper tub support and alignment.

Lid bumper for washer dryer combo units. Cushions the lid when closed to prevent noise and damage. Replace if cracked, missing, or worn out.

Cushions the washer lid when closed to prevent slamming and noise. Replace this rubber bumper if it's cracked, worn, missing, or no longer cushioning.