Gibson Switch

This is a factory switch used in the appliance's control/safety circuit. Replacing a worn or failed switch restores reliable signaling so the selected function engages properly and the unit responds consistently to user inputs and status conditions.

• Provides an electrical on/off signal to the control or safety circuit
• If faulty, selected functions may not activate or may be intermittent
• Can trigger error codes related to a switch input, depending on model

• Disconnect power before servicing; turn off gas/water if applicable
• Note/photograph wire locations and transfer connectors one at a time
• Verify actuator alignment and secure mounting before reassembly
• After installation, run a test cycle to confirm proper operation

Burner not heating or won't turn on? This electric range control switch restores power to stovetop elements. Straightforward DIY repair.

This micro switch detects door or lid position and tells the appliance when the door is closed so cycles can start or safety interlocks stay engaged. It restores reliable door sensing and helps prevent operation with the door open. What it does:

• Acts as a position sensor that completes or breaks the control circuit when the door/lid is closed or opened
• Keeps the appliance from starting or continuing a cycle if the door is open (safety interlock)
• Common symptom fix: appliance won't start, stops mid-cycle, or shows door-related error codes
• Small electrical switch designed to mount at the door latch or frame and connect to the appliance wiring harness

• Disconnect power (unplug or shut off breaker) before attempting service
• Access may require removing panels, trim, or the door latch assembly; keep track of screws and fasteners
• Observe wiring orientation and connector positions; replace exactly as removed or tag wires

Fix washer overfilling or incorrect water levels with a new pressure switch. Solves fill problems across load sizes. Most installs in 5-10 minutes.

Washer overfilling or running without water? Your pressure switch likely failed. This switch monitors water levels to prevent overflow problems.

A push-button switch that restores user control functions by completing or breaking electrical circuits. Replaces a worn or failed control switch to help restore normal operation and user input response. What it does:

• Acts as the user-operated control input to start or stop a function when pressed
• Opens or closes the electrical circuit that enables the associated control or feature
• Common symptom: unresponsive controls or functions that do not start when buttons are pressed
• May cause intermittent operation or no response if contacts are worn or corroded

• One replacement push-button switch

• Disconnect power to the appliance before attempting any service
• Use appropriate tools and basic electrical safety; avoid bending terminals or forcing the new part into place

This capacitor helps start and run the refrigerator's compressor and/or fan motors so the appliance cools reliably. Replaces a worn or failed capacitor to restore normal motor operation and reduce hard-starting. What it does:

• Provides the initial electrical boost motors need to start turning
• Helps maintain steady motor speed during operation
• Commonly linked to symptoms like compressors that hum but don't start
• Needed if refrigerator cycles frequently or cooling is inconsistent

• One capacitor

• Disconnect power before accessing electrical components
• Discharge the capacitor before touching terminals to avoid shock
• Verify wiring and terminal orientation before reconnecting

Washer won't start or stops mid-cycle? A faulty lid switch is often the cause. This safety switch tells your washer the lid is closed. 15-30 minute fix.

If your washer won't advance cycles or overfills, the pressure switch likely failed. This DIY repair restores water level sensing in 15-30 minutes.

Fix a washer that won't start or agitate with this lid switch replacement. Common fix when your washer won't run with the lid closed. Moderate DIY repair.