Parts for Thermador PCG484EW01: Ignitor Parts

If your gas burner won't ignite or clicks continuously without lighting, the spark module may have failed. This electronic component generates sparks reliably.

This replacement cover protects internal appliance components and restores safe operation after damage or wear. It provides a secure enclosure to keep parts clear of debris and moisture. What it does:

• Shields internal motor, pump, or electrical components from debris and accidental contact
• Helps maintain proper airflow/drainage pathways to reduce noise and clogging
• Replaces cracked, broken, or warped covers that cause rattling or expose internals
• Supports correct alignment of adjoining panels and fasteners

• One replacement cover

• Disconnect power and water before beginning any repair
• Remove surrounding panels or fasteners to access the damaged cover; save screws for reuse if undamaged
• Inspect mounting tabs and adjacent components for damage; replace any broken hardware

This 90° elbow fits fluid/gas lines, providing a compact right-angle connection between a 3/8" male NPT fitting and a 5/16" tubing. It helps route lines neatly and prevent kinks in tight appliance spaces. What it does:

• Creates a sealed right-angle transition from 3/8" male NPT to 5/16" soft or hard tubing
• Used where space requires a compact turn in water, refrigerant, or drainage lines
• Can reduce stress on hoses and tubing that would otherwise bend sharply
• Common replacement when fittings leak, vibrate, or become corroded

• Inspect mating threads and tubing for damage; replace any worn seals or ferrules before installing
• Hand-start threads to avoid cross-threading, then tighten with appropriate wrench — do not overtighten
• Use thread sealant or tape only if specified for the application; follow appliance manufacturer guidance
• Disconnect power and water/gas supply and relieve system pressure where applicable before servicing

This part has been discontinued and is no longer available.