Kenmore / Sears Tube Or Fitting

This replacement water tube delivers water from the household supply to the ice maker, restoring reliable filling and ice production. It replaces worn or cracked tubing that can cause leaks or prevent the ice maker from filling. What it does:

• Carries water to the ice maker fill valve so the ice maker can fill and form ice
• Stops and helps prevent leaks caused by cracked or brittle tubing
• Restores normal ice production when a damaged tube is keeping the ice maker from filling
• Helps ensure consistent dispenser or fill-line water flow when properly connected

• Turn off the refrigerator power and shut off the water supply before starting.
• Disconnect the ice maker and remove access panels as needed to reach the tube.
• Inspect fittings and replace any damaged clamps or seals; tighten connections to manufacturer torque where specified.
• After installation, restore water and power, then check carefully for leaks and confirm the ice maker fills normally.

Vent tube that routes hot air and moisture from the oven cavity to the exterior. Replace if cracked, corroded, or disconnected to restore proper ventilation.

Connects the pilot flame to the thermostat in gas ranges. Replace if tube is kinked, cracked, or damaged, preventing proper heat sensing and regulation.

Gas supply tube that connects the main gas line to the top burners on your range. Replace if cracked, damaged, or leaking to restore safe gas flow.

Replace the left front burner tube on your range. Needed when the tube is cracked, corroded, or damaged, preventing proper gas flow to the burner head.

This burner tube connects gas supply to your range burner assembly. Replace if cracked, corroded, or damaged to restore proper gas flow and prevent leaks.

This tubing is the OEM thermo/safet capillary line used with the temperature sensing/thermal safety assembly. It transfers temperature information to the control so the appliance can maintain proper temperature and protect components. What it does

• Carries temperature feedback from the sensing bulb to the thermostat/thermal safety device
• Allows the control to react to temperature changes and open/close circuits as designed
• A damaged or kinked tube can cause inaccurate temperature sensing or control faults
• Common symptom: temperature not regulated or unit cycling irregularly when sensing line is compromised

• One thermo/safet tubing

• Install only if tubing and fittings match the original; avoid sharp bends or kinks in the line
• Handle the sensing bulb and capillary gently to prevent damage
• Disconnect power before attempting service; follow all safety and grounding procedures

Replace a cracked, corroded, or damaged gas manifold pipe on your range. This tube connects gas supply components and ensures proper gas flow distribution.

Burner tube for cooktop gas burners. Connects gas valve to burner head. Replace if cracked, corroded, or damaged to restore proper gas flow and fit.

Burner tube for gas ranges. Delivers gas from the valve to the burner head. Replace if cracked, corroded, or damaged to restore proper gas flow.

Gas tube assembly for cooktop burners. Connects gas supply to rear burner. Replace if tube is cracked, damaged, or has loose connections causing leaks.