Kenmore / Sears Wall Oven Parts

The drip pans I ordered fit my stove perfectly. I was extremely happy. I had tried drip pans from Wal Mart and Lowe's and they wouldn't sit right in the stove. Read more

My son help me to change, and also he changed the belt as it was old. It took him about 45 minutes overall Read more

Replaced the control board and panel. Read more

• Door won't open or close

The replacement hinge unit arrived in just two days. The JennAire (Maytag) oven door is fairly typical in that it easily lifts off of the hinge bars. Once the door is off then removing two screws is all that's required to remove the hinge unit from the oven. The new hinge slides up into place and while you hold it up inside of its location putting the old screws back in is very easy. After sliding the door back down onto the hinge bars the oven is as good as new Read more

Removed the broken ones and replaced with the new ones. Read more

Replaced the control board. Read more

I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since. Read more

I ordered a replacement glass from Appliance Part Pros on Friday evening and it was delivered on Monday morning. It was packed well and I appreciated the quick delivery. I watched the Appliance Part Pros video and it was not helpful because it was for a different door but it did have some useful advice. I checked for a few other hints on the internet and then went to work. The door on my oven had to be removed by opening it to the first stop, about four inches, after removing two locking... Read more

I went to the Appliance Parts Pros website and spoke with Shawn in customer service via the chat option. He was very helpful and suggested I order the thermostat for my stove. It arrived in about a week and I installed it the same day. It was a very easy install with the exception of the wiring harnesses didn’t match so I had to splice the wires together. It worked perfectly and now my stove is working like new. I really appreciate everything Shawn did to assist me and make this project much... Read more

It took a little longer then I was hoping but wasn’t terrible. If the burner is very old at all make sure to get the new screws. Both of mine snapped when trying to remove them. The new one works great. Read more

Looked for solution on YouTube, found the possible solution. Looked up part number on AppliancePartsPros. Ordered it came in two days. Took of back, removed old board. Put in new board. plugged it in. Put back together. Worked fine. 1 hour start to finish. Cost was at least 2/3rds less than a new gas range. Read more

Replaced them in under 30 seconds. Read more