Kitchenaid Wall Oven Hinge Parts

Oven door would no longer close completely, ordered replacement hinges, 30 minute repair. Read more

Watched video from AppliancePartsPros.com, ordered part. I followed instructions on video and oven door works great now!!! Read more

• Door won't close

Replaced the hinge and receiver. Read more

• Door won't close

For the third time in four years, the hinges failed on my KitchenAid wall oven. The appliance is out of warranty and KitchenAid does not consider this to be worthy of any recall. I was tired of paying the appliance repairman to change out the hinges, so I ordered the part online. Appliance Parts Pros is an awesome site for identifying the part you need, and they deliver quickly. Note that you probably need TWO hinges--they do not come as a set--and KitchenAid likes to make their model numbers... Read more

I knew for sure that the hinge with the large spring was damaged, but elected to replace both hinges and receivers. Replacing the parts was fairly easy and would have taken me less then an hour. This model has thin metal covers over the hinge assemblies. I found that squeezing in the sides of the covers help to hold them in place on the hinge while reassembling the door. My only difficulty was putting the door back on the oven. It took a little maneuvering but I managed to get it. Now the door... Read more

Replace two door hinges works great now. Read more

Replaced left and right hinges. Read more

Replaced both hinges. Easiest repair I’ve done on this unit. Took less than 20 minutes from start to finish. Read more

• Door won't close

Replaced the hinges after watching YouTube video. Read more

• Door won't close

This oven was a Kenmore model #66595822003. I replaced both spring hinges. This oven was a white oven so it took the MFG# WP8053807 hinge (order two of them). They are the same hinge. No left or right. To get the door off the oven, open the door all the way open, I installed pins (preferably only 1/4" long) in the holes of both hinges. Then remove the spring steel retainers above old hinges in the oven frame. These holds hinges in place. Now close the door until hinge stops on pins. Lift up... Read more

I replaced the hinges, which involved removing the door by opening it all the way, inserting a small allen wrench into the locking pin hole on each of the two hinges, partially closing the door and pulling it toward me. I then laid the door stainless steel face up on a table, removed the 8 screws from the edge and pulled the bottom of the face up and toward me. The hinges lie loose in their compartments, so it's easy to pluck them out and drop the new ones in. To retrieve my allen wrenches... Read more

Replaced both hinges... simple repair, took about 20 minutes. My only issue is that I replaced these hinges a year and a half ago to repair the same problem. Seems like Whirlpool could have designed a better door. Read more

The repair went very smooth because all I had to do was watch your video. Good job! Read more

Called repairman who said he could not fix it, which I did not believe. Read about issue on line and confirmed the issue to be hinges when disassembled. Ordered, easy replacement, and door works perfect. Did not use backing plates, but likely not worth returning due to freight. Great service by your team. Read more

So after receiving my 2 door hinges, 2 days before est. delivery . All I had to do is take the oven door off, and then remove 4 screws to take the door apart, 4more screws to remove old hinges, replace w/new reassemble and put door back on oven, all in about 40 min. works like new again, Thanks for everything. Read more

I was able to order new hinge receiver brackets for the door. The repair was not that bad. I just had to take off the lower door, take the two trim pieces off the sides and unscrew the screws holding the oven into the face of the cabinet. Then slide it out about halfway and put a step stool under the front to keep it from tipping over. Then it was just a matter of taking off everything around the sides until I could take the brackets off, put the new brackets on, and put everything back... Read more