Parts for Kenmore 484.1464180 (4841464180, 484 1464180): Knife Assembly Parts

This listing indicates the manufacturer has discontinued this replacement part and the exact item is no longer available for purchase through this listing. Check below for next steps and options for replacement. What it does

• Not applicable — the original OEM part is discontinued and not offered here.
• If you were searching for this part due to a failed component, a functioning equivalent or updated replacement may exist from the manufacturer or aftermarket suppliers.
• Common symptoms that led customers to search for this part include the appliance not operating properly, error codes, or a non-working specific component.

• This listing is informational only; no replacement part is included or ships from this page.

• Do not attempt repairs until you confirm a valid replacement part and service instructions for your specific model.
• Contact the appliance manufacturer to identify current OEM replacements or updated part numbers.
• If an alternative or superseded part is available, confirm compatibility with your exact model before ordering.

This actuator is the small control motor that moves internal components to change positions or routes within the appliance, restoring proper mechanical motion and cycle operation. What it does:

• Moves dampers, doors or internal levers so the appliance can change modes or direct flow
• Enables cycle components to engage at the correct time for normal operation
• Commonly replaced when cycles fail to advance, modes don't change, or mechanical parts are unresponsive
• Works as the electromechanical interface between control signals and moving parts

• Disconnect power before inspecting or replacing the actuator
• Handle the motor and wiring harness gently to avoid connector or gear damage
• Use basic hand tools; keep track of screws and any clipped linkages during removal

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This 90° connector (CV136) replaces a worn or damaged right-angle fluid/tubing connector to restore a secure, low-profile hose connection and stop leaks or flow interruptions. It fits the CV136 connector family and matches OEM shape. What it does

• Provides a right-angle connection for tubing or hose runs where space is limited
• Replaces cracked, leaking, or loose inlet/outlet connectors
• Helps restore reliable fluid flow and prevents pooling or drips near the joint
• Works where a compact 90° routing is required to avoid kinks

• One 90° connector (CV136)

• Turn off power and shut off water or fluid supply before replacing
• Inspect mating tubing and seals; replace any damaged clamps or O-rings as needed
• Hand-start fittings to avoid cross-threading, then snug with appropriate tool—do not overtighten