Parts for Ge JES1451BJ01: 03 - Open Cavity Parts

This molded resin cover is a protective plastic shield used inside the microwave. It helps protect internal components and ducting from splatter and debris and restores a secure, finished fit when the original cover is cracked or missing. What it does:

• Shields internal components from grease, steam, and food splatter inside the unit
• Helps maintain proper airflow paths and a snug, rattle-free fit
• Common replacement when the original cover is cracked, warped, loose, or missing
• Visual cue: exposed internal parts or a cover that won't stay secured

• One resin (plastic) cover

• Disconnect power (unplug or switch off the breaker) and allow the unit to cool
• Access the cover location; remove retaining screws/clips and keep hardware for reuse
• Align the new cover and secure it without overtightening
• Ensure the cover is fully seated and not contacting nearby moving parts before restoring power

Replacement glass turntable tray for microwaves. Restores the rotating surface that holds dishes during cooking. Order if your original is cracked or broken.

Brown rotating ring assembly for microwave turntable support. Replaces cracked, broken, or damaged ring. Installs on bottom of microwave cavity.

This wire holder is a small retaining clip that secures wiring or harnesses to the appliance chassis to prevent rubbing, strain, and accidental disconnection. It helps keep wiring routed neatly for reliable operation and safer service. What it does:

• Secures a wire or wiring harness to a mounting point to reduce movement and abrasion
• Helps prevent loose or chafed wires that can cause intermittent operation or electrical arcing
• Keeps wiring routed away from hot or moving components
• Restores proper harness placement after service or if the original clip is broken

• Always disconnect power to the appliance before servicing electrical components
• Inspect surrounding wiring and connectors for damage; replace any frayed or exposed wires
• Clip typically installs into the factory mounting location; basic hand tools may be needed