Kenmore Freezer 253.21101100 (25321101100, 253 21101100) Parts

• Too warm
• Doesn't shut off
• Fridge runs too long
• Freezer not defrosting

Fixed it by replacing the electronic control board. Only 30 min. to fix. (See further down for effort to diagnose the problem.) Most of this "fixing time" was spent removing the control panel to access the control board that is attached to it. My freezer has the control panel located in the top center of the door. The only way to remove the control panel is to pry the panel out of the door using a thin-bladed putty knife.The instructions provided were very good in explaining the process;... Read more

• Won't start
• Too warm
• Fridge too warm
• Freezer section too warm

In short - I replaced the evaporator fan motor and the evaporator fan blade. The Appliance Parts Pros website was extremely helpful to me. Here's how. 1. The site helped me identify that even though my Freezer says it's a Frigidaire, it's actually an Electrolux. 2. The site identified the potential screech causing parts. (I didn't take a chance, I bought all three) It was a worthwhile investment. My freezer is 20 years old so it deserved some help. 3. The site provided guidance videos (not... Read more

Suspected it was the thermostat, since temperature stayed the same at multiple settings over a 24 hr period. There was only three components inside the freezer besides the evaporator, the fan was working, so I decided to just go ahead and replace the thermostat and defrost thermostat. Also replaced the defrost timer by the compressor, just to get all the old parts replaced with new. I had already replaced the compressor, so now I've pretty much have a new freezer. The new parts works great and... Read more

• Noisy

1. After hearing a loud noise on the freezer side of unit about halfway up, I started investigating what it could be? My conclusion was evaporator motor or evaporator fan blade. One of the signs of this issue was a distinct change in sound when I opened the freezer door. I ordered a new motor and blade, not knowing exactly what it was. 2. I couldn't get water to dispense, so I changed the filter and that wasn't the problem. I ordered a water valve and crossed my fingers. These parts arrived... Read more

• Frost buildup

Arrived on time and was a good fit. no problems at all thank you Read more

Replaced the Defrost Thermostat and the DefrostHeater Element. Read more

Had a friend who is an appliance repair tech. Replace the evaporator, the heater coil, and the filter/drier. Parts were soldered together and the compressor was put under vacuum. Then, charged with 5 oz. of refrigerant. The freezer works great now! Read more

I determined that it was a problem that occurred during the defrost cycle by resetting the GFCI outlet and forwarding the defrost timer until the defroster came on. Once the defrosting began, the GFCI outlet would reliably trip. I took apart the shielding inside of the freezer and tested the defrosting without the heating element or the thermostat connected. Since that looked good, I tested for proper functionality of the thermostat by removing it, placing it in a working freezer, and checking... Read more

Quick touch up. The paint worked great. Packaged with a brush like nail poliish Read more

Replaced the fan and blade. Would have been easy except the mounting threads were different than the original Kenmore freezer came with. After a 14 mile round trip for 2 5/32 screws and washers, I had my freezer back. Included an improved wiring harness than the original. Read more

Removed the freezer shelves and back panel, evaporator coils were frozen with ice. Defrosted coil and removed defrost heater connectors, measured no continuity in the heater and ordered a replacement. Also discovered the aluminum retention strap was broken and the heater had slipped down in it's position, ordered and replacement strap. Re-installed new heater and strap per the video instructions, repair complete. Most difficult steps were drilling out the drain pan rivet and re-threading... Read more

Replaced the handle. Read more

I replaced defrost timer (which I am glad I did because of wear on the points) but that did not cure the problem. So after checking other components, I found that the temperature control was the culprit. No problem, I will simply order part # 2162521100. Well Frigidaire decided to obsolete that part and "Has not provided an approved substitute". So, I have to scrap this freezer and pay $800 to $900 for a new one? Not! So I kept looking at subsequent freezer temperature controls and found part #... Read more

I took it apart myself by just un-doing screws and taking it apart. Reversed the process to put it back together. Read more