Kenmore Refrigerator 106.57702700 (10657702700, 106 57702700) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: W10297244
The Ice Stripper Kit is an OEM part for Whirlpool refrigerators. This kit helps in the efficient removal of ice from the ice maker, ensuring smooth and continuous ice production.
Common causes include wear and tear from regular use, buildup of ice or debris, or damage from mishandling during maintenance.
Symptoms of a bad ice stripper kit include:
- Ice cubes not being properly ejected from the ice maker
- Ice jams or blockages
- Reduced ice production
- Unusual noises coming from the ice maker
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Fridge was too cold Jennie W. • Nashville , TN • December 10, 2015
My fridge was too cold - everything was freezing solid, even in the produce bins. The air from the diffuser vent was constantly running. After unplugging the fridge and plugging it back in, the diagnostic code on the control panel indicated that the air diffuser was not working. I purchased a new air diffuser, watched the very helpful video that showed how to install it, and replaced the part in about 10 minutes. The next day, I can tell that everything in my fridge has finally begun to thaw...
Read more
More
$58.43
- Compare At:
-
$70.12
- You Save:
-
$11.69
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489483
The Screw is an OEM replacement part for Whirlpool appliances. The precise threads allow screws to join or assemble other parts securely.
Causes of a bad screw can include stripping, cracking, or loss of threads due to repeated installation/removal over time. Corrosion is also possible depending on environmental conditions.
Symptoms of a bad screw include:
- Loosened or detached components that were once fastened
- Reduced structural integrity of connections or assemblies
- Potential safety hazards if critical parts become dislodged
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Missing hinges to hold the door up Sandra C. • Gardena , CA • June 05, 2016
Found the parts in the diagram of my fridge and simply installed it very easy
Read more
More
$11.78
- Compare At:
-
$14.14
- You Save:
-
$2.36
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2198641
Ice maker cover loose or broken? This bracket secures the front cover to your ice maker assembly. Simple 5-minute DIY repair with basic tools and video guide.
Do-It-Yourself Stories from Customers like You
Ice maker quit making ice spent over $200 for repairman to come and fix worked for two weeks and quit again Milo K. • Seneca , SC • December 15, 2016
Purchased new ice maker from Appliance Repair and replaced the old ice maker and associated parts that broke during attempted repair on my part. Replaced and is working fine.
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10170540
Shoulder bolt screw that secures refrigerator door handles. Replace if missing, stripped, or loose to restore proper handle attachment and alignment.
Do-It-Yourself Stories from Customers like You
Broken door handle Kevin K. • Stevensville , MD • August 08, 2017
Simple Repair.
Read more
More
$11.78
- Compare At:
-
$14.02
- You Save:
-
$2.24
Genuine Whirlpool part
By: Whirlpool
Part Number: W11223328
Shelf tilting or slipping? This support stud anchors your refrigerator shelf to the liner wall, preventing drops and keeping shelves level. Easy DIY fix.
Do-It-Yourself Stories from Customers like You
Broken shelf and drawer. Regina M. • Yardley , PA • November 10, 2017
Myself
Read more
More
$15.95
- Compare At:
-
$18.98
- You Save:
-
$3.03
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3400012
This replacement screw secures panels, brackets, and internal components in Whirlpool-built appliances. Use it to replace missing or stripped hardware to restore a snug fit, reduce rattling, and maintain proper alignment. What it does:
- Fastens components to the appliance cabinet or frame
- Helps maintain alignment and proper clearances
- Reduces vibration-related noises from loose or missing hardware
- Common replacement when a screw is lost, corroded, or threads are damaged
What's included:
Install notes:
- Disconnect power before service; for gas appliances, also shut off gas supply
- Start threading by hand to avoid cross-threading; use the correct driver bit
- Tighten snugly without overtightening to prevent stripping
- Inspect and replace any worn clip/nut or damaged threads
Do-It-Yourself Stories from Customers like You
Broken can Rayniero S. • Rockledge , FL • July 10, 2016
Ordered the parts, took door off the refrigerator. Removed all parts and replace with new parts. Took me about 15 minutes to complete.
Read more
More
$7.48
- Compare At:
-
$8.90
- You Save:
-
$1.42
Genuine Whirlpool part
By: Whirlpool
Part Number: W11566763
Directs defrost water to the drain line in your refrigerator. Replace if cracked, broken, or leaking to prevent water buildup inside the unit.
More
$37.95
- Compare At:
-
$45.16
- You Save:
-
$7.21
Genuine Whirlpool part
By: Whirlpool
Part Number: W11496481
Replace a cracked, broken, or leaking 1/4" water tube in your refrigerator. This cut-to-fit tubing connects internal water components. Easy DIY fix.
Do-It-Yourself Stories from Customers like You
Water filter housing leaking H M. • Picayune , MS • August 18, 2015
Replaced filter housing, and both water tubes
Read more
More
$27.37
- Compare At:
-
$32.30
- You Save:
-
$4.93
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2188755
Rear access cover panel for refrigerators. Shields compressor and electrical components from dust and debris. Replace if cracked, damaged, or worn.
Do-It-Yourself Stories from Customers like You
Leaking water at the water intake valve. Christy C. • Warner Robins , GA • May 01, 2020
My 16 year old son ordered the part and replaced the part. It took him less than 5 minutes to replace the part.
Read more
More
$85.95
- Compare At:
-
$101.42
- You Save:
-
$15.47
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2305382
This rubber boot seals and shields a component or connector within the appliance. Replacing a worn boot helps keep out moisture and debris, preventing corrosion and wear so the protected part continues to operate reliably.
- Provides a protective seal around the targeted connection or component
- Helps keep out moisture, dust, and debris
- Minimizes vibration and abrasion at the connection point
- Direct replacement when the original boot is cracked, brittle, torn, or missing
- Symptoms can include visible damage, loose fit, or signs of moisture/rust near the protected area
What's included: 1 rubber boot Install notes:
- Disconnect power and turn off water supply before starting
- Access the area and note the boot's orientation and seating depth
- Remove the old boot; fully seat the new boot and transfer any reusable clips/covers
- Restore power/water and verify a secure seal and normal operation
Do-It-Yourself Stories from Customers like You
Not delivering ice down the chute, auger not working but it makes ice Richard M. • Coppell , TX • October 06, 2018
New auger motor, shaft, and washer fixed it for about $120 , repair people quoted $500
Read more
More
$6.52
- Compare At:
-
$7.69
- You Save:
-
$1.17
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2198661
This top coupling links two drive components in select washers to transfer rotation smoothly. Replacing a worn or stripped coupling restores consistent agitation/spin and can reduce slipping, rattling, or grinding noises from the drive area. What it does:
- Connects mating shafts/components so power is transmitted through the drive system
- Helps maintain alignment and cushions minor shock to protect other parts
- Failure symptoms may include no or weak agitation/spin, intermittent drive, or clicking/grinding sounds
- Visual clues can include cracks, rounded/stripped splines, or excessive play
What's included:
Install notes:
- Disconnect power; turn off water supply if moving the appliance
- Access location varies by model; cabinet/top or front panel removal may be required
- Note orientation of flats/splines and seat the coupling fully—do not hammer into place
- Inspect the mating hub/shaft; replace worn companion parts to prevent rapid re-wear
Do-It-Yourself Stories from Customers like You
Broken drive on door dispenser for ice maker Richard H. • Bartlett , TN • March 07, 2016
My LG electric dryer stopped drying the other day and I searched on line for suggestions on what may have caused it to stop working. I came across AppliancePartsPros.com and quickly found some of the most common issues with my LG dryer. The problems were listed in the order of most common occurrence, and had extremely helpful and detailed instructions on how to not only diagnose the problem, they also showed exactly how to access and repair the issue. Unfortunately, it was late on a Thursday...
Read more
More
$7.95
- Compare At:
-
$9.54
- You Save:
-
$1.59
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2198608
Ice bin won't release or latch broke? This ice bin latch spring provides tension to secure the ice container properly. Easy 10-minute DIY fix.
Do-It-Yourself Stories from Customers like You
Lower ice bin broken Dennis B. • Wichita Falls , TX • March 30, 2020
Easy to remove the metal parts from the old bin. The only problem was that the screw that holds the adapter has red thread locker and screwdriver rounded off the head of the screw. Drilled the screw and heated the screw to loosen the thread locker and used an ease out to remove the screw.
Read more
More
$9.63
- Compare At:
-
$11.46
- You Save:
-
$1.83
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489478
Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.
Do-It-Yourself Stories from Customers like You
Wanted to update wood paneled compactor Julie S. • San Antonio , TX • December 09, 2014
Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on...
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2305258
Ice falling out of dispenser or chute door won't close? This door chute directs ice flow and seals properly. Typical 30-minute DIY fix for dispensers.
Do-It-Yourself Stories from Customers like You
Ice maker door wouldn’t open Mickey W. • Ponca City , OK • April 20, 2020
Talked to a service rep. and he helped me diagnose what was needed.
Read more
More
$15.47
- Compare At:
-
$18.25
- You Save:
-
$2.78
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2203771
Refrigerator top hinge and pin that mounts to the cabinet and supports the door. Replace if broken, cracked, or worn to restore proper door alignment.
Do-It-Yourself Stories from Customers like You
Needed hinges for doors William H. • Niles , MI • September 22, 2015
Put the new hinges on the doors fyi you need to tell what size the screws are for the hinge kits would help a lot
Read more
More
$56.34
- Compare At:
-
$67.61
- You Save:
-
$11.27
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2196483
Replacement support stud that holds refrigerator shelves securely in place. Needed when original peg is broken, cracked, or missing from shelf wall.
Do-It-Yourself Stories from Customers like You
Broken shelf and drawer. Regina M. • Yardley , PA • November 10, 2017
Myself
Read more
More
$10.71
- Compare At:
-
$12.85
- You Save:
-
$2.14