Kenmore Dishwasher 587.1501190 (5871501190, 587 1501190) Parts

Replacement mounting screw for dishwashers. Secures panels, brackets, and internal components. Replace if stripped, corroded, or missing during repairs.

Protective shield that covers the dishwasher spray arm assembly. Replace this guard if it's cracked, broken, or missing to protect spray arm components.

Dishwasher toe kick panel installs at the base to cover the gap beneath the door. Replace if cracked, dented, discolored, or missing for a clean finish.

This replacement rack wheel restores smooth rolling for a dishwasher rack so dishes slide in and out reliably. It prevents catching, sticking, and uneven rack movement to keep loading and unloading simple. What it does:

• Replaces a worn or broken rack wheel so the rack rolls smoothly along its track
• Reduces scraping, jamming, and noisy operation when moving the rack
• Helps keep racks properly aligned to prevent dishes from tipping or colliding
• Fits upper or lower rack assemblies where this style of wheel is used

• One replacement dishwasher rack wheel

• Designed for a simple snap-on or axle installation; your model's parts diagram for exact placement
• Inspect the rack axle and track for damage and clean debris before installing
• Wear gloves to avoid pinching fingers when removing/installing the rack
• If the wheel does not seat properly, stop and verify you have the matching wheel for your rack before forcing it

This is a #4-40 x 5/8" machine screw used to secure panels, trim, and small assemblies on compatible appliances. It replaces missing or stripped fasteners to restore secure mounting and reduce vibration or rattling. What it does:

• Fastens panels, brackets, and small components where a #4-40 x 5/8" machine screw is specified
• Helps stop loose trim, control panels, or interior parts that can vibrate or shift
• Restores proper alignment when missing or damaged screws cause gaps or movement
• Matches OEM thread pitch and length used in the original assembly

• One #4-40 x 5/8" screw

• Use the correct #4 Phillips or compatible driver to avoid cam-out and head damage
• Start threading by hand to ensure proper engagement before tightening
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic parts
• Disconnect power to any electrical appliance before working on panels or internal components

Secure dishwasher components with this #8 x 5/8" mounting screw. Replace lost, stripped, or corroded screws to properly fasten panels and parts.

This replacement mounting screw secures panels and components in compatible Frigidaire appliances, helping restore stable assembly and safe operation. It's a direct-fit fastener used where the original screw has been lost or damaged. What it does

• Fastens appliance panels, brackets, and small parts to restore secure assembly
• Replaces stripped, rusted, or missing screws that can cause rattling or loose components
• Matches the OEM fit for reliable retention and alignment during normal use

• Use the correct size driver to avoid stripping the head; tighten until snug but do not overtighten
• Disconnect power or follow appliance-specific safety procedures if working near electrical components
• Inspect surrounding hardware and replace as needed

This washer heater assembly heats and maintains wash water temperature to improve detergent performance and cleaning for temperature-sensitive cycles. Designed as a direct replacement part for compatible top- and front-load machines. What it does:

• Heats incoming water to reach selected cycle temperatures for better soil removal.
• Helps maintain water temperature during the wash portion of the cycle.
• Common symptom: washer runs but water stays cold or loads are not cleaned as expected.
• Common symptom: water temperature error codes or washer fails temperature-sensitive cycles.

• Disconnect power and water supply before starting any repair.
• Handle the heating element and wiring with care; avoid damage to terminals and gasket surfaces.
• Installation may require removal of access panels and basic hand tools.
• After installation, restore power and run a short test cycle to check for leaks.