Kenmore Wall Oven 790.41003600 (79041003600, 790 41003600) Parts

A replacement power cord kit that restores the electrical connection for a freestanding range or wall oven, letting the appliance receive mains power safely and reliably. What it does:

• Provides the main AC connection between your appliance and household power
• Replaces damaged, frayed, or burned cords that cause loss of power or intermittent operation
• Helps prevent arcing or poor contact from worn wiring or terminals
• Used when plug, cord insulation, or strain-relief components are defective

• Disconnect appliance from power at the breaker before beginning work
• Inspect terminal block and wire connections; tighten to manufacturer torque if specified
• Route cord and secure strain relief per appliance cabinet opening to avoid pinching

Rubber bumper cushions oven or range doors to reduce noise and prevent metal contact. Replace if cracked, worn, or missing to restore proper seating.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Specs: 8 - 18 x 0.500

Hex flange nut with 10-32 thread secures components in appliances. Replace if stripped, missing, or damaged. Flange provides broader bearing surface.

Replacement mounting bracket that secures internal oven components. Install when original is cracked, bent, or missing to restore proper alignment and support.

Positions and supports range components to maintain proper alignment. Replace if cracked, broken, or missing to prevent rubbing and ensure panels fit correctly.

Replacement 10-24 x 3/8 machine screw secures panels, brackets, and trim in ranges and ovens. Replace missing, stripped, or damaged screws.

Mounting screw for electric range, oven, or wall oven assembly. Secures internal components and panels. Replace if stripped, missing, or damaged.

Replace your worn, cracked, or missing wall oven control knob. This black tapered knob with pointer installs on the control shaft for precise setting.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

Wiring harness for wall ovens. Connects electrical components inside the oven cavity. Replace if wires are frayed, burned, or connections are loose.

This replacement gauge is a direct-fit indicator that restores clear, readable system measurements so you can monitor appliance operation and diagnose issues quickly. What it does:

• Displays system readings on a dial for easy monitoring
• Helps identify abnormal operating conditions such as inconsistent temperatures or pressure changes
• Restores accurate indication when the original gauge is cracked, fogged, or no longer responsive
• Useful for routine checks and troubleshooting basic performance concerns

• Disconnect power and, when applicable, turn off supply lines before beginning work
• Handle the gauge carefully to avoid damaging the dial or lens
• Install in the original mounting location using existing hardware; do not force connections
• Test the appliance and proper readings after installation

Wiring harness assembly that routes power and signals between your wall oven's control and components. Replace when harness is damaged or corroded.