Parts for Ge GCG1580P0SS: 05 - Powerscrew & Ram Parts

Ram slide guide for trash compactors. This component guides the ram mechanism during compaction cycles. Replace if cracked, worn, or damaged.

Bearing plate for trash compactor ram assembly. Replaces cracked, worn, or broken plates that support the compactor mechanism. Structural component.

Replace your compactor's worn or missing sprocket washer. This small but essential component installs between gears to ensure smooth operation.

Replace a cracked, worn, or missing washer cone in your compactor. This hardware component secures parts and maintains proper assembly integrity.

Power screw stud for compactor drive systems. Secures and connects drive components. Replace if threads are stripped, stud is bent, or missing.

Mounting bracket for compactor top limit switch. Secures the limit switch in proper position. Replace if bent, cracked, or broken to restore stability.

A small sealing cap used to close and protect a service port or tubing end, helping prevent leaks and contamination. Replaces a worn or missing cap to restore a tight seal and tidy appearance. What it does:

• Seals off a service port or tubing end to prevent water or air leaks
• Protects the fitting from dirt, debris and corrosion when not in use
• Helps maintain proper system pressure by providing a secure closure
• Can stop minor drips caused by a damaged or missing cap

• Intended for a direct replacement; fit before installing
• Turn off supply (water/electric) and relieve pressure before removing old cap
• Hand-tighten only unless otherwise specified by manufacturer to avoid damage
• Inspect mating surface for debris or damage and clean before installing new cap